Can Convert-A-Ball Trailer Coupler, # CG, Be Welded To The Trailer
Updated 05/18/2010 | Published 05/14/2010
Question:
can this be welded into place
asked by: Donald
0
Expert Reply:
I called the supplier (Convert-A-Ball) and they said the Convert-A-Ball Trailer Coupler, # CG, can be welded, but recommended it be welded by a experienced welding shop.
They also mentioned it would have to be welded at least 12 inches up from the bottom and cooled immediately because there is polyurethane cushions on the inside of the coupler which could be affected by the heat buildup when welding.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Convert-A-Ball Multi-Cushioned Gooseneck Trailer Coupler - Round - 30,000 lbs
- Gooseneck Coupler
- Coupler with Inner Tube Only
- Round Tube
- 30000 lbs GTW
- 2-5/16 Inch Gooseneck Ball
- Manual Latch
- Shock Absorbing
- Convert-A-Ball
more information >
Continue Researching
- Q&A: How To Use the Convert-A-Ball Multi-Cushioned Gooseneck Coupler With Ram Factory Gooseneck Hitch
- Q&A: Replacement Inner Tube For Gooseneck Trailer Coupler That Doesnt Use Through Pin
- Q&A: What Inner Tube do You Have for My Bulldog Gooseneck Coupler that Doesn't Use Load-Bearing Pin?
- Q&A: Replacement Gooseneck Trailer Coupler for Horse Trailer with Round Coupler
- Q&A: Can the Convert-A-Ball Multi-Cushioned Gooseneck Trailer Coupler Be Drilled for Pins
- Q&A: What is Widest Point of Demco EZ Latch Gooseneck Coupler
- Q&A: Gooseneck Coupler That is Needed Longer Than 22 inches
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Is It Illegal to Leave My Hitch on My Truck?