Does Bushing In Redline Rear Spring Hanger # 30-20 Come Out to Allow Spring Installation
Updated 06/10/2015 | Published 06/08/2015
Products Featured in This Question
Question:
Rear Hanger with Bushing for Single Axle Trailer Suspensions with 1-3/4inch Double Eye Springs Does the BUSHING in the front mount POP out so you can use with the Double Eye spring? else, no way to get spring in.
asked by: Phil
Expert Reply:
I pulled a sample of the Redline Rear Spring Hanger # 30-20 to check its construction for you. The included steel bushing is NOT welded into place, just fitted by tension, but it does NOT need to be removed to install a double eye spring. The bushing's hole takes a 9/16-inch shackle bolt like # 126B2. The shackle bolt secures the two shackle straps, like # 115052, on the OUTSIDES of the hanger. The other ends of the straps then hold the spring's eye with another bolt.
Product Page this Question was Asked From
Rear Hanger with Bushing for Single Axle Trailer Suspensions with 1-3/4" Double Eye Springs
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 2-1/8 Inch Tall
- Single Axle
- Dexter
more information >
Continue Researching
- Video: Redline Trailer Suspension - Leaf Spring Suspension - 30-20 Review
- Q&A: Spring Hanger Dimension Recommendations for Installing a e34SR Leaf Spring
- Q&A: How is the 30-20 Hanger Designed For Mounting On Its Side and Not Facing Down
- Shop: Replacement Wet Shoulder Bolt - MORryde Suspension Upgrade Kits - 9/16" x 3-3/8" - Qty 1
- Shop: 6-Leaf Double-Eye Spring for 5,300-lb Trailer Axles - 24-7/8" Long
- Shop: Rear Hanger with Bushing for Single Axle Trailer Suspensions with 1-3/4" Double Eye Springs
- Shop: Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers -3-1/8" Shackle Straps
- Shop: Step Wet Bolt for 1-3/4" Double Eye Springs
- Shop: Spring-Eye Bolt with Locknut for Slipper Springs - 4" Long
- Search Results: trailer spring hanger
- Search Results: 6 leaf trailer leaf springs
- Search Results: trailer spring mount
- Search Results: shackle mount
- Search Results: trailer suspension parts
- Q&A: How To Mount Redline Rear Hanger # 30-20 On A Trailer
- Q&A: How Does the Rear Hanger Get Welded to the Trailer Frame
- Q&A: Bushings To Replace Lippert Never Fail Bushings
- Q&A: Functions of Wire Colors on Lippert Components Slide-Out Switch
- Q&A: Replacing Slipper Springs With Double-Eye Springs
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: Where to Position the Trailer Axle?
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)