Hitch Recommendation for a 2002 Dodge Ram 1500
Published 06/04/2015 >
Products Featured in This Question
Question:
I have a 2002 dodge ram 1500 with the step bumper. The bumper has three holes 4 inch center on each. There are no additional holes. I use the middle hole for my ball. I would like to take the ball off and mount an step bumper hitch to under side of the bumper to lower and level my trailors. I have not been able to find one with three holes or even two with the right spacing. To use all three holes, they need to be centered 4 inches. To use the two outer holes, they need to be centered 8 inches. Thank for an ideas
asked by: William G
Expert Reply:
For your 2002 Dodge Ram 1500 you would want the Curt hitch part # 13326 as it was custom made to fit the mounting holes you have at the back of your truck. Check out the install video I attached as well.
Product Page this Question was Asked From
Curt 2" Trailer Hitch - Bumper Mount - 8-3/4" Bolt Pattern - 5,000 lbs GTW
- Bumper Hitch
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Front Hitch Recommendation for Bike Rack for 2004 Fleetwood Tioga
- Q&A: Recommended TorkLift Hitch and Extension for a 2025 GMC Sierra 2500 w/a Camper Pulling a Trailer
- Q&A: Can Dylux Tankless RV Water Heater Be Used In Winter? Does It Have Freeze Protection?
- Q&A: Front Mount Hitch for 2000 Ford E-450
- Q&A: Does Front Plastic Valance Get Removed to Install Curt Front Hitch # 33055
- Q&A: Dual Hitch Adapter for Towing Boat Trailer and Carrying Bikes
- Q&A: How to Determine the Correct Replacement Wiper Seal for a 2017 Keystone Bullet 243BHS
- Article: Trailer Wiring Diagrams
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight


