Can Bulb be Replaced on Peterson Red Flush Mounted Sealed Turn Signal Light 435800
Published 06/02/2015
Products Featured in This Question
Question:
is bulb replacable on this light? what is replacement bulb #
asked by: Anthony K
0
Expert Reply:
Peterson brake/turn signal light # 435800 is sealed and cannot be opened up to change out the bulb. I pulled one from the warehouse to verify this and cannot get the lens off (without breaking it) to access the bulb/interior of the light.
What I recommend is to use an LED light, # STL43RB, because the LEDs will last much longer than a regular incandescent bulb. For a grommet use # A45GB and for a wiring harness use # A45PB.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Peterson Trailer Tail Light w/ Grommet and Plug - Stop, Turn, Tail - Incandescent - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 4-1/4 Inch Diameter
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement LED Trailer Light for Petersen 410-25 Light
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: What Hole Size is Needed for Flush Mount of Peterson # 435800 Sealed Tail Light
- Q&A: Replacement P02860 Grease Seal For Lippert Axle On 2019 Keystone Cougar
- Q&A: Replacing American CS6000XL in Camper
- Q&A: Replacement for 5973820 Motor for Kwikee Series 28 RV Step
- Q&A: Replacement Converter for PD9245C that is Lithium Battery Compatible
- Article: What Do I Need To Tow A Trailer?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern