How Would the Optronics Mid Ship Clearance Light # ST75AB Wire in as Just a Blinker
Published 06/01/2015
Products Featured in This Question
Question:
How would you wire the mid ship marker light to make the turn signal indicator work but not light up when the brake light is activated? I thought the brake light and turn signal for the trailer were the same circuit.
asked by: Neil B
0
Expert Reply:
To separate the turn signal circuit from the brake circuit you would need the part # C56196 if you wanted to use the Sealed, 6-1/2" Mid-Ship Turn Signal and Side Marker Light # ST75AB as just a turn signal indicator.
I attached a picture that shows how it will wire in.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Sealed, 6-1/2" Mid-Ship Turn Signal and Side Marker Light - Amber
- Trailer Lights
- Clearance Lights
- Marker
- Turn
- Oval
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 6-1/2L x 2-5/16W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Leaf Spring For Dexter Leaf Spring # 072-099-01
- Q&A: Do Demco Surge Actuator Couplers and Straight Tongue Couplers Have Same Bolt Pattern
- Q&A: Recommended 2-1/2" Long Amber Clearance or Marker Light for a Boat Trailer
- Q&A: Replacement Coupler Solution for Atwood Yoke Style Coupler with 15775 Part Number
- Q&A: Can Velit Diesel RV Heater Heat 288 sq ft Snowmobile Trailer
- Q&A: Determining Correct Replacement Leaf Spring For Trailer W/ 3000lb Axles and 27" Long Springs
- Q&A: Is The TowSmart 14 Gauge, 4 Conductor Wire 100% Copper Wire?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Where to Position the Trailer Axle?
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: My Trailer Hitch Doesn't Fit