Can Peterson Round Flush Mount Trailer Light be Installed in 1/8 Inch Thick Diamond Plate
Published 06/01/2015
Products Featured in This Question
Question:
i am mounting tail lights in 1/8 diamondplate. is this the product i want? i just want to cut the holes and mount with a rubber grommet. i do not want to have to attach light in back or anywhere else. your video explains nothing about mounting also is a matching clear backup light available?
asked by: Anthony K
0
Product Page this Question was Asked From
Peterson Trailer Tail Light w/ Grommet and Plug - Stop, Turn, Tail - Incandescent - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 4-1/4 Inch Diameter
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement LED Trailer Light for Petersen 410-25 Light
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Article: Trailer Lighting Requirements
- Q&A: Replacement Converter for a BW Series 6400
- Q&A: How to Rewire an Old Cattle Trailer
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: What Hole Size is Needed for Flush Mount of Peterson # 435800 Sealed Tail Light
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Article: What Do I Need To Tow A Trailer?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)