Spindle Washer And Grease Cap Replacement For Trailer

Updated 05/07/2015 | Published 05/06/2015

Question:

This is on a trailer axle. It uses bearings 25580 and LM67048 and seal 10-36. Looking for the spindle washer, but all I see listed is the smaller OD washer. Also looking for a dust cap for same axle. It appears to be 2 5/16inch ID and 2 5/8inch OD, and sticks out approximately 1. I appreciate any help you can give me.

asked by: Liz

Expert Reply:

The outside diameter of the washer will not fill the inside diameter of the hub. Washers are only intended to be able to fit over the threads on your spindle and fit against the outer bearing.

We offer a bearing kit that has the inner and outer bearing, races, and seal along with a cotter pin. To order this kit you will need part # BK3-300.

To find the best fit for a grease cap on your trailer you will need to measure the inside diameter of the hub. If the inside dimension of your hub measures 2-5/16 inches, the closest we have for a grease cap is part # F001526, but this is designed for a hub dimension of 2-5/8 inches.

expert reply by: Jeffrey L