Trailer Hitch and Wiring for a 2008 Infiniti EX35
Updated 05/06/2015 | Published 05/05/2015
Products Featured in This Question
Question:
Where can I find installation instructions for this hitch is there a video that goes over how to install?
asked by: Jim
Expert Reply:
We have not had the chance to install Curt trailer hitch # C11510 on a vehicle which is why there isn't a video. But I have included a link to the installation instructions for you.
If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class I trailer hitch. Also, with a bike rack, you are limited to 2 bikes maximum on a Class I hitch.
Curt also says you have to use stabilization strap # 18050 when using this hitch for any non-trailer load (such as a bike rack or car go carrier) per their warranty requirements.
If you plan on doing some towing the proper ball mount to use is # C45521. For a 1-7/8 inch ball use # 19256 and for a 2 inch use # 19258. And for trailer wiring use # C59496.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 150 lbs TW
- 1500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Is there a Spacer for the Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump?
- Q&A: Trailer Hitch Receiver Recommendation for 2011 Infinity EX35
- Q&A: How Do I Eliminate Slipping and Close the Gap on My Retrax XR Tonneau Cover?
- Q&A: Recommended Replacement for ShurFlo Water Pump 2088-404-144, the HydroMax P25201
- Q&A: Pull-Rite Capture Plate for a Rota-Flex
- Q&A: Is Class III Trailer Hitch Available for a 2015 Infiniti QX50
- Article: How to Choose the Right Trailer Hitch Class
- Article: Stability Control for Heavy Duty Vehicles