Hitch and Trailer Wiring Recommendation for a 2015 Hyundai Sonata
Published 04/24/2015 >
Products Featured in This Question
Question:
Hello, I just purchased 2015 Hyundai Sonata Limited. I am intend to install a towing hitch on it. My trailer has 5-pin-end connector, while your LED 4 Flat Powered Converter Vehicle End is with 4 pins. Do you have a kit with Stop and tail lights on separate lines 5-pin-end? If not, is it is possible the stop lights to overpass the converter box and supply harmlessly the trailer stop lights? Thanks,
asked by: Angel K
Expert Reply:
For a trailer hitch for your 2015 Hyundai Sonata you would want the Draw Tite Hitch part # 24965.
For trailer wiring you would want install the # C56365 and then make a converter adapter so that your taillight signals match up.
The Vehicle to Vehicle Taillight Converter # 118158 would work well to separate the combined turn signal circuits from your 2012 Subaru Outback with combined wiring to the separate wiring of your trailer. This would be the only product you would need.
Basically, you would want to mount this product somewhere near the connector on your trailer and then splice the wiring in. The box is labeled to let you know exactly which wire goes where, but you will need to run the right turn/stop light from your trailer connector to the green wire on the input side of the box that is labeled right turn/stop.
The white wire will ground to the frame of the trailer and the yellow wire of the box will run to the left turn/stop light circuit.
On the output side you will run the green wire to the right turn circuit, the red wire to the stop lights, and the yellow to the left turn circuit. I attached a picture that should help also.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Locating 12 Pin Plug to Install Trailer Harness in 2019 Honda Ridgeline
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement for 3,500 lb Axle With 92-1/2 Inch Hub Face Measurement
- Q&A: Wiring Harness for 2009 Honda Pilot
- Q&A: Availability of Trailer Hitch for 2009 Honda Pilot
- Q&A: Connector Location for T-One Black Box on a 2019 Honda Ridgeline
- Q&A: Comparing Trailer Wiring Harnesses For a 2010 Honda Pilot
- Q&A: How to Install Wiring Harness in 2019 Honda Ridgeline
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Brake Controller Installation: Starting from Scratch



