Recommended Brake Controller And Wiring For 2007 Ford E-450 Van
Updated 04/16/2015 | Published 04/15/2015
Products Featured in This Question
Question:
What do you recommend for brake controller and all parts needed to add electrical connector. I am looking at installing a hitch and need all of the items This is a new install on a 2007 ford e 450 shuttle bus. I was recommended to look at a weldable hitch.
asked by: Mike C
Expert Reply:
The brake controller I recommend for your 2007 Ford E-450 is the Tekonsha Prodigy P3, part # 90195. This is one of our most popular controllers because it is easy to install and operate.
I also recommend the brake controller adapter, part # 3035-P. This simply plugs into the back of the brake controller and the other end plugs into the connector located under the driver side of the dash below the fuse assembly. There are 2 connectors under the dash and you want to make sure you use the connector that has a red wire, blue wire, and green wire.
If you have no connectors at the back of your E-450 you will need to install part # C56020. This plugs into the existing wiring on your E-450 with no cutting or splicing needed.
You will then need part # ETBC7. This will plug into the 4-way connector and with additional wiring will give you a 7-way connector needed for towing a trailer.
When working with electrical connectors I recommend using dielectric grease like part # 11755. This keeps dirt and moisture out of the electrical connections and helps prevent corrosion.
Since we do not offer any custom fit trailer hitches for your E-450, you can check out the provided link to find a hitch that will work for you. When selecting a weld-on hitch you should always have it installed by a certified professional welder.
I have attached links to some installation videos you can take a look at.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Q&A: Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
- Q&A: Does Draw-Tite Class IV Hitch Fit 2004 Forest River Georgetown SE on F-53 Chassis
- Article: Trailer Wiring Diagrams
- Q&A: Max Width of the Curt Trailer Hitch Receiver C14082
- Q&A: Will Curt Trailer Hitch Fit a 2016 Fleetwood Bounder 36H Motorhome
- Q&A: Curt Trailer Hitch Receiver # C14082 Tube Height From Mounting Flange For 1973 Ford F-100
- Q&A: Can The Seals On A Kwikee Level Best 3000 Leveling System Be Replaced
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Hitch Installation Tips
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)