Replacement Frame Brackets for Reese Weight Distribution Systems

Question

Question:

does both right and left side w/handle?

asked by: Howard

0

Expert Reply:

The part # RP21501 includes one lift bracket. If you need two brackets you would want the part # RP6637 instead. This comes with a lift handle as well.

expert reply by: Jameson C

0

Answer 1

Although each Weight Distribution (WD) system manufacturer has their own chain brackets, they are a pretty universal fit. The Curt hangers, parts #C17003, #C17005, and #C17008, haven't been tested with a Pro Series WD system but they should fit…

view full answer...

Answer 2

The Replacement Lift Bracket #C17008 that you referenced could be used with the part #C17062 weight distribution system. The brackets are slightly different than what came with the kit but they will still work just as well. As long as you stay under…

view full answer...

Answer 3

Because your trailer is fairly heavy, I would recommend you go with 2 of the #58392 lift brackets. The 58392 has extra gusseting welded to it for reinforcement, and would be better suited to a heavier trailer like yours, because the spring bars will…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Frame Brackets for Reese Weight Distribution Systems

Continue Researching