Recommendations for 5th Wheel Trailer That Rides Nose High  

Question:

Expert Reply:

If the 5th wheel trailer is riding nose high, the hitch weight will be too low and can lead to ride problems with the towing vehicle, bad trailer sway, and tracking problems with the trailer.

The first thing I would do in your situation is take the truck and trailer to your RV dealer and have them check out your setup. Typically 5th wheel trailers are set up to tow a bit pin high to allow for more weight transfer to the rear most axle or axles on the trailer.

There are a few ways to lower the nose of a trailer besides adjusting the 5th wheel hitch, which you have already done. The pin box can some times be raised up on the trailer by switching to higher installation holes on the frame of the trailer. Be aware that adjusting the trailer too close to the top of the truck bed can result in damage though. You should have about 6 inches of clearance between the truck bed rails and the underside of the trailer loft to account for pitch and roll of the trailer.

Another option is to lift the trailer. You can do this by moving the axles from being above the leaf springs to below the leaf springs.

The diameter of your trailer axle will determine the size of the parts that you will need to order. If your axle is 3 inches diameter, the Dexter Trailer Springs Over-Under Conversion Kit, # K71-385-00, would be a great choice, and if your axle is 2-3/8 inch diameter you could use the Over-Under Kit, # K71-384-00. These kits can be installed without welding but the manufacturer strongly recommends having the new spring seat tacked in place on the other side of the trailer axle.

expert reply by: Chris O

0