Distance from Center of Pin to Mounting Surface on the Bolt-On Spring Latch # SL716SS
Updated 02/25/2015 | Published 02/24/2015
Question:
On part SL716SS - the bolt on spring latch - I want to know where the center of the hole is on the base for the pin. I just want to know how high the pin sits
asked by: Carly L
0
Expert Reply:
The distance from the mounting surface of the Bolt-On Stainless Steel Spring Latch # SL716SS to the center of the pin is 5/8 of an inch.
I went and pulled one of these from our warehouse to take this measurement.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Bolt-On Stainless Steel Spring Latch
- Trailer Door Latch
- Reversible
- Spring Latch
- Non-Locking
- Bolt-On
- Stainless Steel
- Redline
more information >
Continue Researching
- Shop: Bolt-On Stainless Steel Spring Latch
- Q&A: Setting the Power Output and Boost Settings on a Tekonsha P3 Trailer Brake Controller
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement For A Dexter 8-249 Hub And Drum Assembly
- Q&A: How Do I Know Which MORryde WDH Storage Bracket To Use On Jayco Keystone Camper ?
- Q&A: Can MORryde WDH Storage Rack Stay On Trailer's Frame While Towing?
- Q&A: Can The MORryde Storage Bracket For WDH Stay On The Trailer's A-Frame While Driving?
- Q&A: Replacement Trailer Hub Seal for TCM 12194TC
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Idler Hub for 3,500 lb Big Tex Trailer Axle with 5 on 5" Bolt Pattern
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Lighting Requirements
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps