Information About Optronics Sealed 3-Light Identification LED Light Bar
Updated 02/24/2015 | Published 02/23/2015
Question:
why does your info on the mcl-97rb say it has 2 50inch leads, then say that it is grounded through the mounting hardware?
asked by: Brian
0
Expert Reply:
The Sealed, 3-Light Identification LED Light Bar, part # MCL97RB is a single wire light. The item is grounded through the mounting hardware and the base. You have one wire that is attached to your power source. The mounting holes are spaced 8-1/2 inches on center.
I have attached a product review video you can check out that explains this in the demonstration.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 14L x 1W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Is Drilling Or Trimming Required To Install The EcoHitch EH72HR On A 2025 Hyundai Ioniq 5?
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Are the BP01-301 Brake Magnets the Same as BP01-330 Brake Magnets?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Ranger Trailer Cool Hub Replacement Grease Seal AD2527E
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Article: Trailer Maintenance Schedule
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)