Jack Recommendation for a Trailer that has a Pipe Mount that Is 2-3/8 Inch OD and 2 inch ID

Published 02/04/2015

Question:

I have a 1988 4 Winns trailer under my 4 Winns 20 Captiva deck boat. The weld on trailer jack stand needs replacement. I measure the outer tube diameter to be between 2-3/8 and 2-7/16inch and the inner tube diameter of 2. Might you have a jack to fit the welded mount?

asked by: Jim B

Expert Reply:

The Bulldog Round, Pipe-Mount Swivel Jack # BD178203 is designed to fit a pipe mount that has a 2-1/2 inch outer diameter and a 2 inch inner diameter which is very close to what you have on your trailer. As long as the pin hole on your pipe mount is 5/8 inch in diameter this jack would work well for you. I attached a review video for you to check out as well.

This is a 5,000 lb jack that should work well for you.

expert reply by: Jameson C