Can the B&W Pintle Hook Mounting Plate # BWPMHD14004 be Used in Rise Position
Published 01/07/2015
Products Featured in This Question
Question:
Hello, Can this part be used upside downinch to raise the pintle hitch on the vehicle? As shown in the bottom picture?
asked by: Steve
0
Expert Reply:
Yes, the B&W Pintle Hook Mounting Plate # BWPMHD14004 can be used in the rise position if needed. If used in the rise position, the # 63058 pintle hook mount would measure 11-1/2 inches from the bottom of the shank to the top of the plate.
If you need a pintle hook you could use the part # C48205. This has a 10k capacity. Check out the review video.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
B&W Pintle Hook Mounting Plate for 2" Hitches - 13" Shank - 14 Hole - 16,000 lbs
- Pintle Hitch
- Mounting Plate Only
- Adjustable Height
- 16000 lbs GTW
- 2 Inch Hitch Mount
- 14 Holes
- Standard Shank
- B and W
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Pintle Hook And Mount With 8 - 10 Inch Rise
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Raised Pintle Hitch Mount With 25000 lb Capacity
- Q&A: Equalizer Recommendation that is 7-3/4 inches Long and 2.875 inches Tall
- Q&A: How To Tow Military Trailer with Lunette Ring Using 2" Hitch
- Q&A: Availability of Heat Strip or Heat Pump for Furrion Chill Cube RV AC
- Q&A: Can Curt Pintle Hook Mounting Plate # C48342 be Used in Rise Position
- Q&A: Replacement Gear and Handle for Bulldog Jack BD195362
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Pintle-Hitches
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft