Bracket and Shaft Recommendation for Use with the Yates Flat Bow Stop # YRJONBLOCK
Published 01/05/2015
Products Featured in This Question
Question:
What bracket assembly and size shaft should be bought with the 5 3/8 flat bow stop?
asked by: Cory
0
Expert Reply:
The Yates Flat Bow Stop, # YRJONBLOCK , requires a 1/2 inch diameter shaft like # CE10700A . The bracket you mentioned, # CE32004G , takes a 5/8 inch diameter shaft so a 1/2 inch diameter will fit but it will be loose. Out of the parts that we carry this would be the best combination for your application.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Yates Flat Bow Stop for Boat Trailers - Heavy-Duty Rubber - 5-3/8" Span - 1/2" Shaft
- Boat Trailer Parts
- Guards and Pads
- Bow Stop
- Rubber
- Fits 1/2 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Internal Dimensions for Suspension Hangers
- Q&A: Replacement Gear Box 28 Series Steps on 2000 Itasca Spirit
- Q&A: Will the Hydraulic Trailer Brake Kit part # AKFBBRK-35 Work With 13" Wheels
- Q&A: Recommended Wood for Bunk Boards on Boat Trailer
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Q&A: Replacement Winch for Non-Serviceableet Pre-2007 Fulton T1200 Winch
- Article: How to Make Your Next Boondocking Trip the Best Yet
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Replacement Parts to Rebuild Trailer Suspension on 1976 EZTrail
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Boat Trailer Guides: Which are the Best?
- Article: Most Popular Wheel Bearings