Brake Mounting Flange Bolt Pattern of the Kodiak Disc Brake Kit # K2HR35E-8
Published 12/09/2014 >
Question:
What is the bolt hole spacing on the 4 bolt flange bracket ?
asked by: Paul
0
Expert Reply:
The bolt pattern that the brake mounting flange of the # K2HR35E-8 is designed to bolt to is a 4 bolt on 4 inch bolt pattern. This is a very standard bolt pattern. Chances are very good that if your spindles have a 4 bolt mounting flange on them this would bolt right to it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 8" Rotor/Hub - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Upgrading 8" Hydraulic Brakes to Disc That Will Fit a 10" Wheel and Tire
- Q&A: Electric Brakes for 10 Inch Wheels
- Q&A: How to Add Hydraulic Drum or Disc Brakes to a Pontoon Boat Trailer
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: Disk Brakes Compatible with 4400 lb Axle
- Q&A: Hydraulic Disc or Drum Trailer Brakes for 10 Inch Wheels
- Q&A: Replacement Hub / Disc Brake Kit For EZE-TOW Tow Dolly With 5 On 4-1/2
- Article: Best Boat Trailer Jacks
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Lighting Requirements


