2019 Chevrolet Suburban Off Road Lights

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for…

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

You do not want to use a holding tank heater like ThermaHeat #277-000164 on a battery but we do offer battery heaters specifically intended to protect one from extreme cold. You can see all such items on the page I linked for you.…

From the looks of the photo you sent it does not look like you have an OEM suspension system on your boat trailer. I recommend securing the suspension rail to the trailer frame in a more secure manner like drilling and using bolts so that it does…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

As it seems you already know, when installing a trailer brake controller on your 2007 GMC Yukon you will need to locate the two wires under the hood that need to be connected to fully activate the vehicle's tow package. One…

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

A #93 incandescent bulb has a single contact bayonet base, and there are a couple of options for LED bulbs that will replace these. You can choose a bulb that gives off either a warm or cool light; I have added a photo showing the difference…

You'd need a new panel like the Progressive Dynamics Mighty Mini part #PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible. There isn't a center section…

I spoke with my contact at Progressive Dynamics and they informed me that the Lithium Converter for WFCO RV Power Centers part #PD4655LIV does work as an upgrade for the Parallax 7355. It has the same housing as the Replacement Converter for…