2013 Jeep Wrangler Jeep Hardware

Hello Kristi, thanks for reaching out. The Furrion Chill Cube RV Air Conditioner is only available in the 18K BTU at this time. This particular unit you were looking at, part #LC54DX comes with the AC unit only, but we do offer it as a kit that comes…

Hello Earl, thanks for reaching out. The Front Runner Footwell Water Tank #FR79JJ may fit in your 2023 Toyota Tacoma Access Cab. This is not a fit we have tested here at our shop though, so the only way to know for sure will be to check the…

The drawer dimensions of the MORryde Trail Kitchen for Jeep Wrangler Or Wrangler Unlimited #MR83MR are 15-3//4 inch wide by 25-1/2 inch long by 6.6 inches tall.

Yes, there is Sal. However, it is only available in a kit as far as duct-less goes. It is the Furrion Chill Cube RV Air Conditioner w Air Distribution Box item #FR27TD. This includes the 18,000 btu Furrion Chill Cube and an air distribution box for…

Hey Myron, thanks for reaching out. We just installed and tested one of these Chill Cube units here in our install bay a few hours ago, and we tested the amp draw. With just the fan running it was pulling only like 0.5 amps. It is pretty cold here in…

Hey William! I don't have a way of knowing how much space there is on a 2023 Gladiator without one here to test it. What I can tell you is that the #FR95DJ measures 2-5/8" long x 50" wide x 21-11/16" tall so you can use those…

Hey Roger, while the fan speed of the Furrion Chill Cube RV Air Conditioner #FR59TD is variable that function does not act as a capacitor or a Softstart. For a Softstart you'd want the part #SSR54FR. This will allow the initial start up of the AC…

The top tray on the MORryde Camping Kitchen with Storage Compartment for Jeep Wrangler #MR83MR measures 0.947" so you're looking at just under an inch tall, which I confirmed with my contact at MORryde. Hope this helps you out!

Hey Brandy, yes you would be able to open the rear door of your 2020 Chevy Equinox with the Curt hitch cargo carrier part #C18152 installed and it would have clearance.

The height of just the mounting bracket of the MORryde part #MR73QR is 6.6 inches and the length is 30 inches. It weighs 84 lbs.

The first step would be to determine the exact bolt pattern of the wheel. If you click the provided link, you'll be taken to an FAQ article that shows exactly how to do this. Once you determine the bolt pattern, you can compare that information…

The CE Smith #CE27310G spare tire carrier you'd mentioned would work well for your trailer frame. The carrier is compatible with trailer frames up to 4 inches tall and from 1 to 3-1/2 inches wide. The carrier is compatible with wheels with 4 on…