2018 Cadillac ATS Vehicle Engine Heaters

The Kat's Heaters Custom Fit Engine Block Heater #KH11813 is the correct option for your 2022 Toyota Tacoma with the 3.5L V6. I have linked an installation video we did on a 2016 Tacoma for you to reference and see where the heater will…

Hello Robert, thanks for reaching out. The Kat's Heaters Custom Fit Engine Block Heater #KH11812 is what we recommend for your 2023 Hyundai Tucson 2.5L. This is a cartridge style heater that will clip on to the cavity of the engine…

Christopher, I did some research, and it looks like it should be by the exhaust on the driver's side of the engine, underneath the driver's side door. Immediately behind the driver side exhaust header there is a factory…

For your 2018 Toyota RAV4 with the 2.5L I4 engine the Kat's Heaters Custom Fit Engine Block Heater #KH11813 will work perfectly. This cartridge heater will clip right into the cavity of your engine block and submerges in the coolant to…

Kat's does recommend coating the cartridge with NSCG silicone grease G-624 before inserting the cartridge heaters like the #KH11813 into the block.

The Kat's Heaters #KH11813 is an aftermarket engine block heater that is confirmed to fit your 2009 Toyota Tacoma TRD Off-Road with the 4.0L engine (we do not carry Toyota OEM replacements parts). That being said, it's also…

As long as you have found the correct hole in your 2015 Toyota Tacoma the Kat's heater part #KH11813 would be correct for it and should slide right in. Since the hole is somewhat difficult to access you are most likely not angling it in…

The correct engine block heater for your 2017 Toyota RAV4 Limited with the 2.5L I4 engine is the Kat's Heaters Custom Fit Engine Block Heater part #KH11813. According to Kat's, the block heater will need to be installed on rear left…

I really wish we had the chance to install the Kat's heater #KH13150 so we could provide an install video or pictures but the best is the following written instructions: To install the heater you will first need to drain the cooling system.…

To replace your 16" x 6" dually trailer wheel, I recommend the Vesper Steel Dual Trailer Wheel item #TA56FR. This wheel has a 3,860 lbs capacity, a 8 on 6-1/2" bolt pattern, and a 4.77" pilot diameter. I…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Derrick, I checked directly with TorkLift for you, and the TorkLift Tie Downs - Front and Rear #TL87DR are a fit for the 2024 Ford F-350 with the bed access step near the cab. The #TL87DR are also specifically for an 8 foot long bed as well as…