Headache Rack Specs:
Features:
Protect yourself and your cab from shifting loads with this headache rack that features a strong and durable steel frame. The louvered screen shields you from the sun without obstructing your view. Includes cutout for third brake light.
Installation Notes:
Drilling required for installation
More Information >Headache Rack Specs:
Features:
Get that rugged, aftermarket look while protecting your cab from shifting cargo with this Aries headache rack. Customize with LEDs and tie-down anchors that attach in the top channel. Brake light is clearly seen through the top slot.
Installation Notes:
No drilling required for installation
More Information >Videos
for Headache Rack
Help Articles
for Headache Rack
Expert Answers
for Headache Rack
The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…
view full answer...I recommend replacing an entire ladder if it's damaged. You'll want to find a replacement based on the height. Such as the Stromberg Carlson #LA-401 that is 99-1/2 inches tall. They can be cut shorter to customize the length if…
view full answer...The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be…
view full answer...While trailer axles do feature an upward bend like you are describing, there isn't a particular amount/measurement that is standard across the board. This bend in the axle is designed so that it will straighten under a trailer's loaded…
view full answer...I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.
view full answer...When installing the Tekonsha Prodigy P2 Trailer Brake Controller #90885, we need go back under the dash to find the factory wiring on your truck. Now it's located behind the dash underneath the steering wheel just a little towards the left and a…
view full answer...Hey Chris, the overall height of the Aries AdvantEdge Headache Rack #AA88VB that you referenced is 26-1/2 inches. It's not difficult to remove but wasn't designed for getting removed and installed super easily. There's no reason it…
view full answer...The etrailer Invisible Base Plate Kit #e86YR is compatible with compatible with all etrailer, Demco, and Blue Ox tow bars so you won't need an adapter to connect to your Aventa II tow bar.
view full answer...If by serial number you mean VIN and the trailer manufacturer is still in business then yes, you would likely be able to obtain the bearing numbers from the manufacturer. If none of the above are true, then the only other way to determine which…
view full answer...When it comes to replacing the motor on your electric two step stairs on your 1988 Fleetwood Pace-Arrow The Motor Upgrade Kit for Kwikee Electric RV Steps #LC29VR is the correct kit for you. This conversion kit will fit step series 22, 23, 28A, 32,…
view full answer...The Thule WingBar Evo Crossbar System part #TH711520, part #TH480R, and part #THKIT1803 while installed on your 2019 Toyota Highlander will indeed need to be positioned so that the door clip is located 13-1/4" back from the rubber molding…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...