Grille Guards Specs:
Features:
Protect your vehicle's front end, and give it an aggressive aftermarket look with this carbon steel grille guard. Integrated mounting points in middle crossbar let you add off-road lights. Bolt on installation with included hardware.
Installation Notes:
No drilling required for installation
Product will interfere with any front end sensors or cameras, if equipped
More Information >Grille Guards Specs:
Features:
The contoured steel tubing and double-hood-bar design of this guard protect your grille, headlights, and front bumper while providing rugged styling for your vehicle. Rubber-coated uprights shield grille guard from damage. No-drill installation.
Installation Notes:
No drilling required for installation
Cutting of air dam is necessary for installation
Tow hooks must be removed (if equipped)
More Information >Videos
for Grille Guards
Help Articles
for Grille Guards
Expert Answers
for Grille Guards
I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem…
view full answer...Pace Edwards has two confirmed fitting Switchblade covers for your 2024 Chevy Silverado 3500 DRW 8' bed; part #PE87CV, which is an aluminum and vinyl mix and part #PE77CV, which is just aluminum.
view full answer...There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we don't have any way to reference a VIN so you'll need…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...We do have replacement mounting hardware for the Aries Grille Guard on your 2008 Toyota 4Runner. If you have the #AA2058 the correct brackets and hardware are the #AABRKT-2058. If you have the #AA66XB then you need the #AABRKT-2066.
view full answer...The Replacement Hardware Kit #AABRKT-5056 will fit the Aries Pro Series Grille Guard #AAP5056. This is the upgraded version of the Grille Guard #AA5056 which uses the same install hardware to attach to a truck.
view full answer...The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.
view full answer...Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.
view full answer...It sounds like you're looking for a replacement installation kit for a Westin Sportsman Grille Guard that fits a 2009 Ford F-150. If so, the Replacement Mounting Kit for Westin Sportsman Grille Guard #40-250PK is the…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That…
view full answer...We recommend that all trailer tires be inflated to the max psi stated on the sidewall of the tire. If the tire is under inflated, the weight capacity is lowered to an unknown amount for that tire. Although running lower air pressures can improve…
view full answer...