Grease Cap For 1.95 Inch Trailer Hub Bore
Updated 08/07/2023 | Published 08/04/2023
Question:
The ID of my trailers hub is 1.95. Which dust cap would fit?
asked by: Guenthet
0
Expert Reply:
The correct grease/dust cap for a 1.95 inch trailer hub bore is the following:
- Grease Cap # TRAG-DC-196
This has a flange diameter of 1.957 inches which is exactly what you'll need as they are meant to be ever so slightly larger for a tight fit as this is a drive-in cap.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Grease Cap - 1.957" Outer Diameter - Drive In
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.96 Inch O.D.
- 1.96 Inch
- 2000 lbs Axle
- 3500 lbs Axle
- TruRyde
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: Bearing Protectors for a Trailer with a 1.950 Inch Hub Bore
- Video: Installing the etrailer Easy Grease Trailer Idler Hub Assembly
- Shop: Bearing Buddy Bearing Protectors - Model 1968SS - Stainless Steel (Pair)
- Shop: Grease Cap - 1.957" Outer Diameter - Drive In
- Shop: Bearing Buddy Bearing Protectors - Model 1968 - Chrome Plated (Pair)
- Shop: Snap-In Plug for Lionshead Trailer Wheel Center Caps - Chrome
- Q&A: Grease Caps With Outer Diameter Smaller Than 1.988 Inches
- Q&A: Correct Replacement for UFP H-1377 Trailer Hub
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: Replacement Bearing Recommendation for H-1377 Idler Hub
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Q&A: Replacement Hub Assembly That Uses Inner Bearing LM67048 and Outer Bearing LM11949
- Q&A: Replacement Threaded Grease Cap for 1.98" Hub Bore
- Video: Fulton Grease Cap Spec Review