2012 Jeep Wrangler Unlimited Fender Flares

Yes, you can! Both the Curt item #C99FR and etrailer item #e75ZR hitches have been confirmed to fit the 2022 Toyota Highlander XSE's with dual exhaust. These hitches are essentially identical with the exception of the finish. I recommend going…

The correct replacements we offer for the Glo Brite Marker Lights 118A and 117R is the Trailer Clearance or Side Marker Light part #MC44AB for amber and part #MC44RB for red.

Hey Annabelle thanks for the information. I have a solution for you. However, we have found out in the last year that the Advent replacement options either don't work at all, are a mess to rewire because the pins don't line up with the…

Hey Tim, thanks for reaching out! The Advent Air RV Air Conditioner System #ADV92SR is only compatible with the Advent Heat Strip #ADV34QR when it comes to adding heat to the RV. For an AC system that's compatible with a furnace you need the…

I do have almost everything you will need to repair your Roadmaster Sterling Tow Bar SN #005384 but after speaking with my representative at Roadmaster, they strongly advised me that you should replace the tow bar due to the sheer age of the unit and…

We have found that the Replacement Motor #LG-142178 that you referenced is indeed compatible as a replacement for your existing Atwood 75722 motor.The only thing I recommend doing is verifying that the legs on your motor aren't flush with the…

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

The lights you referenced in the photo for the Aries Front Fender Flares #AA1500201 wouldn't be factory lights. There is a similar product available for your 2012 Jeep Wrangler Unlimited that work with the aforementioned Fender Flares. The Aries…

We have what you need. I will list them below for you. The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 for your 1 inch D-rings. The etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount - 2" Hitch - 6,000…

For a bumper mounted spare carrier that has capacity for an 80 lb setup we have the part #BR56VR from Brophy that fits a 4 inch bumper like you have and would work well.

Demco has a base plate kit that fits your 2016 Jeep Rubicon Hard Rock with the part #DM56GV which is correct fit with the Demco Commander II part #DM9511012 you have as well.

Based on the measurements you have provided it sounds like you have pretty standard wheel studs. Kodiak stud #K12WB2 is nearly spot-on as far as the measurements. I have included a picture showing its measurements for you.