car emblems - Camaro

You will want a slider hitch like you mentioned to prevent the nose of your trailer from hitting the cab of your 2019 Ford F-350 since you have a short bed truck. The slider hitch allows the pivot point to move back and give you the needed clearance.…

I attached a picture that shows the install instructions for the Demco Capture Plate part #DM6025 that you referenced.

Hey Tod, the two UWS boxes have different shapes and capacities. If you check out the attached pictures you can see the differences between the part #UWS08298 and #UWS01044 to get a better idea. The #UWS01044 has a slightly smaller capacity at 8.2…

There is a wet bolt kit made specifically for a tandem axle trailer with Road Armor equalizers, and includes the shackles, wet bolts, and hardware needed. What you need is the following part: - Lippert AP Kit - Tandem Axle Road Armor Wet Bolts and…

Hello John, thanks for reaching out. For the wet bolts you can measure the overall length or the length not including the head. Honestly when replacing this stuff, the bolts are going to be a standard length and diameter. Typically I would not even…

The Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs #AP233 is the standard suspension kit. For a heavy duty option, we have the Dexter Axle Heavy-Duty Suspension Kit for Tandem Axle Trailers - 1-3/4" Double Eye…

Hey Floyd! Where have you heard that? I haven't come across it on our site and I don't see anything out there on forums or anywhere else. We haven't tested the etrailer Hard Tonneau Cover #e75DR with a power tailgate yet but as far as I…

Hey David yes, the etrailer Hard Tonneau Cover #e75DR will work with your 2024 Toyota tundra with the deck rail.

The towing capacity of the 2003 Chevrolet Avalanche 1500 with 5.3L V8 and 4.10 rear axle is 8100-lbs. For a 7600-lb GVWR travel trailer the resulting 500-lb safety margin is adequate/low-ish. With a trailer that weighs substantially more than the tow…

Hey Steve, yes a Rock Tamers mud flap kit like the part #RT47VR would work with the Weigh Safe adjustable ball mounts part #WS68RR and #WS56ZR. The ball mounts have enough clearance on the shank to allow the Rock Tamers to fit.

I actually just went and test-fit SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 yesterday and discovered that the #SN99FR (4-pack) and #SN77FR (1-pack) are a compatible fit.

The receiver tube portion of the Curt Trailer Hitch Receiver part #C13002 will extend out past the rear bumper fascia on the 2015 Cadillac SRX so the center knockout panel cannot be reused unless modified. This will be the case for all aftermarket…