Videos
for Tie Down Straps
Help Articles
for Tie Down Straps
Expert Answers
for Tie Down Straps
Hey James, so the thickness of the Small Coin Vinyl flooring #TS97FR that you referenced is 90 mil thickness.
view full answer...I recommend using the 601 Flooring Adhesive in a 1 Gallon #TS76FR or 4 Gallon #TS26FR depending on your application. The 601 does not have the pressure sensitive requirements of the 801, 1 Gallon #TS86FR and 4 Gallon #TS58FR adhesives.
view full answer...The caliper bracket you are looking for is the Replacement Mounting Bracket #KCMB12D which is compatible with the 5 bolt mounting flange you have as well as the 225 Kodiak Dacromet calipers you have as well. Then for a bolt kit…
view full answer...To install the Small Coin Pattern Vinyl Flooring #TS97FR with the RV Flooring Adhesive #TS76FR you just need to make sure that your trailer floor is a bare wood so you have the best bonding of the adhesive as possible. Be sure to sweep it out…
view full answer...The stop light switch that you will need to connect the red wire to on the Brake Control Plug-In Harness for Tekonsha part #20127 may be pre ran to a set of wires taped to the underside of the drivers side vehicle dash. If the wires are not present…
view full answer...The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.
view full answer...I have attached a link to our selection of 8 inch trailer hub assemblies that use the common 4 on 4 inch bolt patterns for you to filter through. To choose the correct one you will simply need to remove the current hub on your trailer and check the…
view full answer...You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…
view full answer...The Kodiak Oil Cap #KPCAP you are looking at is a replacement cap for the Kodiak Pro Lube Kit. The oil cap you need is the Redline Oil Cap, Plug and O-Ring for Dexter 7-9K Trailer Axles #RG04-230. This will replace the oil cap on your trailer axles…
view full answer...The correct brake controller install harness for a Tekonsha controller in a 2006 Chevy Silverado is the part #3015-P. If you want to easily install the controller this would be all that…
view full answer...I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...