Keep your slides moving with Lippert RV slide out parts, from motors and controllers to gear packs, tracks, and wiper seals. For a sure fit, match fixed vs float sides and measure the arm for gear packs, and when pairing controllers and motors verify the gear ratio like 300:1 or 500:1. If operation is erratic, check the ground wire first, and consider adding an o-ring during installs.
Include the O-ring during install to help prevent a return trip for seals. On gears, align any orientation marks to keep timing correct. For wiring, be ready to swap wire leads if colors are reversed. If DIY feels challenging, note that some installs aren't simple; using videos and measuring carefully reduces headaches.
Match the kit to the side of the room as viewed from outside. Fixed side goes on one side with a bearing block that doesn't move; float side goes opposite and is designed to allow movement. Check the alignment flange location before install. Verify which side of your assembly has the non-moving bearing block to avoid a half-tooth misalignment.
Measure the arm size to determine the correct gear pack. Common sizes include 2" x 2", 2.5" x 2.5", and 2" x 3" or 3" x 3". Lift the slide box slightly with a floor jack and wood to take tension off during replacement. If your slide made noise, inspect for missing or damaged gear teeth before ordering.
Verify your ground wire connection first. Corrosion at the ground can cause failures that seem like a bad motor or controller. Clean the contact, replace the end, and use a new screw if needed. Also look for simple wiring issues like reversed wire colors and confirm the motor space in case a minor bolt change is needed.
Some in-wall repair kits do not fit inverted systems. Confirm whether your system is standard or inverted before ordering. Check gear orientation marks so the notch lines up; misalignment can leave gears a half tooth off. If your system is inverted, select parts explicitly listed for that configuration to avoid a mismatch.
Controller Parts
Filters
