Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…
Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…
Hey Ethan. From the mounting point of your RV to the top of the carpeted base is going to be 2.31" on the MORryde RV Cargo Slide Tray item #MR78RV. The bottom of the tray sits 1.57" above the mounting point on your RV and the wooden base is…
You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…
While there is no visual guide available to determine the sizing for the MORryde sliding cargo trays like the #MR38FR, it really depends on the height, length, and depth of your RV compartments opening. The #MR38FR that you were looking at, for…
Hey Arthur, The dimensions I'm seeing for a 3500watt Predator Generator show it being 22.8" L x 17.3" W x 20" T so if you're wanting it to sit with the 17.3" side facing out the closest fit would be the MORryde RV Cargo…
Hey Paul! The PullRite SuperGlide #PUL43RR (2714) and #PUL73RR (2914) do weigh the same. The main difference is the capacity, which is going to come from the base of the 5th wheel hitch. Since your 2027 Keystone Cougar 316RLS has a GVWR of 12,900 lbs…
The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…
Hello again Bob, On the MORryde RV Cargo Slide Tray - 90" x 29" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR69FR the overall dimensions are 90" long x 29" wide x 6-5/8" tall, the actual tray dimensions are 88-1/4"…
Hey Laura, as long as the sizes match like you've noted that they do the Furrion #FR77AD would fit and work great in place of what you have now! With RV microwaves like this there really isn't more to it than that. How did you like the…
Thanks for the great service. The order arrived at my doorstep yesterday afternoon. Thank you for making sure the order was complete. I installed the hitch and wire kit last night with no problems. The instructions were perfect. Bruce
Bruce
Maplewood, MN
MORryde RV Cargo Slides for Smooth Access
Load up confidently with MORryde RV cargo slides that make batteries, generators, and fridge/freezers easy to reach. Choose single-side or 2-way designs that extend 60 percent to grab gear from either side. If your bay has a door lip, a height adjustment kit can raise the tray 2-1/2", 2-3/4", or 3-1/8" to clear it. Expect smooth travel and solid support once it's bolted in place.
Installation is straightforward and can take about 2 hours. The instructions can be ambiguous when separating the frame from the cargo holder; take your time and locate the stops before removal. On uneven ground, be sure the latch engages to help prevent the tray from rolling back. Use appropriate bolts, washers, and lock washers for your mounting surface.
Yes—MORryde has 2-way slides that extend 60 percent in both directions. One-way trays are also available with 60 percent extension. Decide if you need access from both sides or just one. Verify the extension percentage for your specific size before mounting to ensure you can reach what you need.
Pick a width that clears your narrowest door opening. Some listed widths have a slightly smaller actual width, so confirm the spec before ordering. Check lip height too; adjustable brackets can provide 2-1/2", 2-3/4", or 3-1/8" of lift. If a center cross support sits lower than the tray, a 3/8" spacer under the frame can help clear the door threshold.
Match your gear's size to the inside tray dimensions, not just the overall size. If space is tight, inside brackets can be removed by drilling out rivets to gain room. For tall or heavy items like batteries or appliances, confirm door height and tray capacity, and make sure the latch position lets you load and unload safely.
Filters
