Videos
for Hand Tools
Help Articles
for Hand Tools
Expert Answers
for Hand Tools
The Firestone In-Cab Pressure Gauge #F2196 will work with the AirLift systems. If you can tell me the part number of which AirLift kit you have I can try and help you with that system if you'd like.
view full answer...The socket needed for the Fastway e2 is the 1-7/8" 12pt Thin Walled Socket #ALL643216.
view full answer...You could upgrade your axles to a higher capacity, however it isn't really recommended since it can create a rougher ride. Since you've got 3,500 lb axles I'd stick with those and upgrade your suspension with the SumoSprings Trailer…
view full answer...Thanks so much for that info it was really helpful, and we do have the right Equal-i-zer weight distribution hitch for your trailer with 850 lbs of tongue weight; the correct part is the following: - Equal-i-zer Weight Distribution System #EQ37100ET…
view full answer...Yes, we have the Thule Wingbar Evo roof rack part numbers #TH711520 and #TH33ZR that fits your 2023 Jeep Wrangler Unlimited that has the one touch roof. The Wingbars are the quietest and most aerodynamic bars out there so we recommend them highly.
view full answer...First I recommend using the Roadmaster Direct-Connect Base Plate #RM-521453-5 on your 2022 Jeep Wrangler 4xe. This will pair with their Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar #RM-676. You will need to measure the height of the receiver…
view full answer...Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
view full answer...EZ Lube axles like the item #T3584F-EZ-8974 come from the factory with just a little bit of grease in the bearings. The first time you use the EZ Lube feature to fill the axle, it will take a lot of grease. You will probably use 3/4 to a full tube…
view full answer...Yep! The 1-7/8" 12pt Thin Walled Socket #ALL643216 does work with the e2 Fastway round bar weight distribution systems. This socket costs considerably less than the Equal-i-zer socket and works just as well so it's what we normally…
view full answer...We have a couple of different options that will work with your Sky One-Touch power top but I'd say the best option is going to be with Thule's aerobar setup. You'll need the following components: Thule WingBar Evo Crossbars #TH711520…
view full answer...I really like the Air Lift WirelessAIR Suspension System for Air Helper Springs Kit #AL27DQ for your 2024 Chevy Silverado 3500 because it comes with an EZ Mount system for easier compressor installation on your truck, and then the kit also comes with…
view full answer...For your 2021 Coachmen Encore on the Ford F-53 22,000lb Chassis we have the Air Lift Front #AL88240 and Rear #AL57344 air bag helper springs. I recommend installing the Air Lift Load Controller Compressor System #AL25856 to control the air pressure…
view full answer...