Car Emblems - F-150

Hey Tod, the two UWS boxes have different shapes and capacities. If you check out the attached pictures you can see the differences between the part #UWS08298 and #UWS01044 to get a better idea. The #UWS01044 has a slightly smaller capacity at 8.2…

You will want a slider hitch like you mentioned to prevent the nose of your trailer from hitting the cab of your 2019 Ford F-350 since you have a short bed truck. The slider hitch allows the pivot point to move back and give you the needed clearance.…

I attached a picture that shows the install instructions for the Demco Capture Plate part #DM6025 that you referenced.

The back portion of the UWS Secure Lock Truck Bed Chest #UWS08298 is 12-1/2" tall and the canister for the RetraxPRO MX Hard Tonneau Cover #RT80384 is going to sit 11-5/8" down from the top of the bedrails. From what I can find online a…

Hey Steve, yes a Rock Tamers mud flap kit like the part #RT47VR would work with the Weigh Safe adjustable ball mounts part #WS68RR and #WS56ZR. The ball mounts have enough clearance on the shank to allow the Rock Tamers to fit.

Hey David yes, the etrailer Hard Tonneau Cover #e75DR will work with your 2024 Toyota tundra with the deck rail.

Hey Floyd! Where have you heard that? I haven't come across it on our site and I don't see anything out there on forums or anywhere else. We haven't tested the etrailer Hard Tonneau Cover #e75DR with a power tailgate yet but as far as I…

The receiver tube portion of the Curt Trailer Hitch Receiver part #C13002 will extend out past the rear bumper fascia on the 2015 Cadillac SRX so the center knockout panel cannot be reused unless modified. This will be the case for all aftermarket…

The BAKBox 2 Collapsible Truck Bed Toolbox #BAK92120 is specifically designed to mount to the side rails on BAK tonneau covers which are going to be different on your REV cover. So you will need a toolbox which fits down inside the bed like the UWS…

What you would need is a front hitch for attaching your winch to your 2012 Chevy Silverado 1500. For that you would need the part #65052 which is a confirmed fit. Then for a winch mounting plate you would want the part #BDW20011 which will fit in the…

I spoke to Demco about the Demco Autoslide Locking Plate for Lippert Rhino Pin Boxes part #DM76FR, the side plates are supposed to be angled as that's what provides the clamping force. I would just make sure you have the bolts torqued fully to…

I definitely see where you're coming with when it comes to towing using the 18K Demco Autoslide 5th Wheel Hitch #DM69GV and Locking Plate #DM76FR for your 2022 Ram 3500. On questions like this I always like to refer back to the owner's manual…