Good morning Lisa! Yes these two brands come up a lot since they are both great quality, name brand options. NOCO makes solid jump starters like the 1,250A #NOC48VR, but one big advantage of Projecta models like the #VX63NR 1,200A and #VX73NR 1,400A…
Hey David, the Replacement Locking Lever Latch part #TH85ME that you referenced does fit your older model RodVault from before it was a Thule brand rack. It's only option to get replacement keys unfortunately which I know is super frustating.
The Curt trailer hitch part #13703 can fit trailer's with I-Beam frames like what you have as long as the frame channels are between 22 and 72 inches apart measured on the outsides. I attached an install video for you to check out as well.
Yes when you do an over-under kit you have to weld the seats to the axle for it to be installed properly. It is recommended to tack weld the new spring seats into place but a complete weld job is not required when installing the over-under conversion…
Yes, if done properly you could use JB weld to attach the spring seats of the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 to your axle.
It is recommended that the spring pads be tack welded in place when installing the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 to avoid the axle slipping but aside from that there is no other welding. I have attached the installation…
You don't have to weld anything with the Dexter Trailer Springs Over-Under Conversion Kit item #K71-385-00. This kit is completely bolt on. It eliminates the prep work, welding, and painting that you would have to do if you just welded a new…
The over-under conversion kit, #K71-384-00, is a bolt on kit, welding is not required for installation but the manufacturer instructions state that tacking the spring seat is strongly recommended. This kit is designed for 2-3/8 inch diameter axles.…
Hey Alex, welcome back! There's a couple of options for spacers depending on how tall of a lift your 2014 Nissan Xterra has. Timbren recommends leaving a 1/2" gap between the item #TJRC01 and where they contact on your Nissan. How big of a…
Good question, and between the K-Source Snap & Zap and Longview towing mirrors for your 2022 Chevy Colorado, the best option is the Longview, with the correct fit for your '22 Colorado being the following part number: - Longview Custom Towing…
Yes, because based on my research your 2021 Grand Design Imagine 17MKE travel trailer uses LaSalle Bristol waste valves, so the correct replacement handles in black and gray are the following: - Replacement Handle for LaSalle Bristol Cable-Actuated…
The Optronics LED Clearance or Side Marker Trailer Light is available in Red #MCL0030RBB and Amber #MCL0030ABB. These are the closest replacements to the Glo Brite 122r/122y lights you have. The lights only have one LED diode versus the 3 in your…
Filters
