Most Popular Locks Not Included for 2014 Nissan Leaf

Bike rack was even sturdier than I expected. Easy to assemble, and shipped quickly. Good experience

I like the overall design of this rack, but unfortunately after hauling a couple bikes around for a while the point where the crossbar connects has apparently rounded off so the rack swings back and forth. I've used rope to tie the ends of the rack to the car to stop this from getting worse, but it's inconvenient. Note: the hitch connection itself is good and solid, but the point where the crossbar connects to the bar coming from the hitch has gotten loose and there's no way that I can see to tighten it.

The good: I like the way the bikes are held in and the ability to add the upright adapters to the bike frame holders. The straps are quality too. For a jeep with a spare tire, this is the perfect length to clear it. This rack is 5 stars from the bike holders to the base of it. The bad: the 2"receiver adapter and bolt are insufficient. I wish they made this in a solid 2" hitch. The entire setup is held into the receiver by a very short bolt. It only goes about half way into the receiver tube. So your hitch is only "secured" on one side. A hitch pin or bolt should go through the receiver tube completely imo so it can be secured on the other end with a retaining clip or nut. Because this only goes in the one side, the entire weight of the rack plus bikes are held tight to one side of the receiver by the undersized bolt and washer. A few bumps down the road and that bolt loosens. Now instead of distibuting the weight of the rack and bikes on the receiver and post, it's completely up to the bolt to keep you from losing the rack. The bolt threads get damaged too. I took this down a dirt road and nearly lost everything. I had to buy my own bolt with hd fender washers and lock washers to correct this. Thule should've provided this from the start. The current short bolt design where only one side of the receiver secures the rack is unacceptable. This rack is 1 star at best for the connection to the receiver.

Click to Enlarge

I bought this bike rack back in April but wanted to make sure I used it to give the best review. First I want to say I did a lot of research on bike racks and found this one to be the best one to fit my needs. The best price I found was on etrailer.com, at the time it was When I called the customer service to place my order, I spoke to Dan. He was very pleasant on the phone and took the time and listened to what I needed and understood my concerns. I ordered the bike rack and also ordered the Thule Snug Tite Hitch Lock and Anti-Rattle Device and the Thule Cable Lock w/ One Key System Lock. Dan suggested I also get the Thule Bike Adapter Bar, which I never even thought of getting. Delivery was in about two business days, which was really fast and at the time of order they were running a special free delivery over $99. When I went to put it together I noticed I was missing the flat cap screw M6 x 16mm, part number #853-5787-02. I emailed Dan and within 24 hours received an email that the part was sent out and also in the email their was a link to track the order. After I received the part I did notice that the flat cap screw was actually in the 2 inch adaptor sleeve. The instructions were very easy to read, and it took me about 20 minutes to put together. I did have an issue when I positioned the stinger into the cradle, with the 8mm locking nut, it was not staying tight and when I took it off I noticed the threads inside were gone, so I ended up going out to Lowes and buying a new one and its holds perfectly fine. I also had a question about that part because it is not a locking part and was worried someone would try to steal the rack. I contacted etrailer.com to find if they make a locking device for this and they said no but I can contact Thule to double check, I'm still waiting for an answer back from Thule. The weather finally broke and we installed the rack onto my hitch, tightened it and it doesn't rattle. When I finally used the rack and put my bike on, it did sway a little but at 50 mph I was very happy with it. The trailer comes out just enough away from my car that I do not have to fold completely out and I can open my trunk with no issues. I am very happy with my purchase and had a great customer experience with Dan. Would highly recommend ordering from them to anyone.

Click to Enlarge

Click to Enlarge

I ordered this for my 2019 Nissan Leaf and tried installing it this morning. It was recommended by etrailer for my vehicle. The big problem is that the lower hooks that are supposed to attach to the bottom of the rear door are too curved to fit into the Leaf's door groove along the bottom when the door is closed. You may have to open the rear door a bit to get them to fit which would be a hassle. It looks like this will work but if it does not I will have to return it. Even the non-curved hooks do not work when the rear door is closed. You can see from the picture the problem with the hooks with the Nissan Leaf rear hatch door. They are to flat on the back to fit into the groove at the bottom. Otherwise, it seems to be a good bike carrier. I just wish it fit better.

Works great for my 2019 Jeep Renegade. I adjusted it to be open a little more, so I could use my rear wiper. It also keep pressure off the rear spoiler.

Just returned from my first trip using this rack. 1400 mile round trip to go to the GAP Trail. Very impressed with how solid the rack is. There are anti-sway mechanisms at the hitch and both folding mechanisms. There is absolutely no wobble. I also got the locking hitch pin so no worry about someone stealing my rack. My only wish is that there was some way to lock the bike to the rack.

I was looking for a light weight bike rack for my 2015 Honda Accord. Your videos stated that the Kuat Beta was light and easy to install. You were right. I opened the box, read the instructions, and had it installed in about 10 minutes. I don't use a rack lock. It is so easy to pop on and off the hitch that I keep the rack in my car trunk.

Click to Enlarge

Excellent and prompt customer service! When I first ordered my product it wasn’t in stock— staff were quick to let me know and offered me comparable products. I ended up waiting for my original order and shipping quick and they stayed in touch with ideas! Thule: The instructions could be a little more detailed. I ended up watching YouTube videos to help me instal. Overall it was easy, and this was the first rack I’ve ever installed and I did it by myself! I was surprised to learn the bike rack is in no way secured inside your vehicle, so.. I store it in my garage when it’s on.

Click to Enlarge

Positive: The product is well thought out and works for a wide range of automotive vehicles. It comes with interesting dampers that i think work. Instructions seem to be translated from another language, but are quite good, accompanying pictures make installation straightforward. A test drive over speed bumps shows that the rack will support the bike for all travel needs. It can be disassembled , collapsed and stored in the trunk. Downside: The rack is made for the classic triangular shaped frame: horizontal cross bar, "male" bike. For bikes without the horizontal bar, mounting is a little less satisfactory. Such a bike can only be mounted on the outside mounts. Cannot use the damper on one side. Picture shows the mounting. as to a design solution, maybe brackets could be replaced with smaller profile, some adjustability? however, as it is, vibration control is good and adjustability with smaller profile would have vibration concerns.

Click to Enlarge

I ordered this for my 2019 Nissan Leaf and tried installing it this morning. It was recommended by etrailer for my vehicle. The big problem is that the lower hooks that are supposed to attach to the bottom of the rear door are too curved to fit into the Leaf's door groove along the bottom when the door is closed. You may have to open the rear door a bit to get them to fit which would be a hassle. It looks like this will work but if it does not I will have to return it. Even the non-curved hooks do not work when the rear door is closed. You can see from the picture the problem with the hooks with the Nissan Leaf rear hatch door. They are to flat on the back to fit into the groove at the bottom. Otherwise, it seems to be a good bike carrier. I just wish it fit better.

Service was excellent. Won't be using the rack until it warms up a bit.

I would give this 10 stars! Sturdy, super easy to use and looks sporty. One of the nest bike racks I have ever used. Downside is I can't use the rear windshield wiper when it is installed, but the awesomeness of the rack makes it worth it.

I just received this item and installed it on my 2018 Nissan Leaf. Since this is the first time installing it, It took me a while to sort out the straps that attach to the vehicle. Once I did this installation went pretty smooth. I noticed that one cannot attach the bottom straps without popping the hatch a little which makes it difficult to close the hatch again. A work-around this issue is to attach the bottom straps along the side of the hatch and slide them around to the bottom. This way you don't have to pop the hatch at all. Once everything is tight the rack appears to be sturdy, although I have not tested it with the full weight of a bike yet, which is why only 3 stars.

Fits perfectly on our Lexus CT200h. Only on the old LS400, the side straps have to be fastened to the wheel arch edge, since the upper trunklid gap is to narrow for inserting the strap hooks. Mounting of two bikes is (with some routine) quickly done, and they stay safe even for longer and faster routes. For transporting three (mountain) bikes, though, the design doesn't seem big and robust enough. Nevertheless, the price-benefit-fun ratios are way better than reasonable.

Click to Enlarge

We are very pleased with the quality and ease of use for our like-new purchase. From the online shopping experience with etrailer.com through multiple outings already, this bike carrier more than meets our needs. Thank you!

I had to put my electric bikes into this rack, backwards, to make them fit. Not ideal, but it works.The receiving 'trays' that are intended to provide support for holding the bikes, by being placed under the bike tires, are forced to be moved to a location that is not directly under the bottom of the bike tires. While it works in this manner, it is not ideal.For the support that attaches to the diagonal bike frame, we had to remove it from the vertical rail of the rack. We reinstalled it, upside down, because that's the only way we could make it fit, or 'grab', the bike frame. Again, we made it work, but it's not ideal. We chose to keep the rack because it was so much less expensive than the Thule rack we considered buying. The bike shop owner didn't agree with us. He observed that we are putting $3000 worth of bikes on the rack and risking that investment. So far, no problems, other than the ill-fitting installation.

Click to Enlarge

Click to Enlarge

With a few adjustments this rack has delivered. Needed to add additional strapping since the provide straps for securing the bikes to center bar were not long enough due to my ebike design (Velotric). My bikes are step through with a thick frame so provided straps won't fit. Simple adjustment with strapping resolved minor issue. Speed of 73 mph on the highway and some bumpy VT roads and this rack performed.

Click to Enlarge