We do carry the 33" Ark Stabilizer Jack that you are looking for with part # ARK77FR.
I was able to track down a few drawings that you should find helpful. These are for the 30" # ARK94FR and the 24" # ARK34FR Stabilizer jacks. I'm afraid we don't have a drawing for the 33" jack. view full answer...
The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information.
The JR Products Automatic Changeover RV LP Gas Regulator # 37207-30395 is rated for 345,000 BTU per hour for the Service Cylinder and 260,000 BTU per hour for the reserve cylinder.
The JR Products Compact Low Pressure 2-Stage Automatic Changeover RV LP Gas Regulator... view full answer...
I do have a potential option for you, but unfortunately we do not offer an air bag kit for your 2023 Chevrolet Silverado 1500 High Country Duramax 3.0L 4x4 with adaptive ride control suspension. We do have the # F2609 kit from firestone which does fit trucks with the adaptive ride control, but it will not fit Diesel models.
We would have to go in a different direction to enhance the suspension on your truck. Your best bet will be a RoadActive Suspension Custom Leaf Spring Enhancement... view full answer...
Yes, you can swap out your cap sensors for internal sensors and they will work with your current TST-507-RV-4 system. We offer the internal sensors individually with part # TST-507-INT-S1. Definitely a good idea if you don't want to have to worry about a sensor going missing. The internal batteries usually last at least 5 years. view full answer...
We have spoken to Fan-Tastic Vent about this issue in the past, and they have confirmed that there are no replacement remotes available for the 6500 model as it's no longer in production. So if you want to still use your existing fan but also wanted a remote, they said what you can use is the Fan-Tastic Vent 7350 Series Upgrade Kit # FV807359.
However, this is similar to getting a brand-new vent, so you can go that route, with a number of different options. For a powered lift with a remote... view full answer...
We definitely have a solution for you that will allow you to carry your two bikes though not the exact adapter you are asking about that already has a ball mount. The first option is to use a dual hitch adapter which does have the needed clearance between the top and bottom receivers, though you do need to ensure you get the one that has the correct rise or drop.
For that you can use the Roadmaster Dual Hitch Receiver Adapter, 6" Drop/Rise # RM-077-6, 8" Drop/Rise # RM-077-8 or 10" Drop/Rise... view full answer...
Yes, the Blue Ox Patriot BRK2012 does have a built in battery backup. So if the vehicles battery starts to go low, you have a bit of reserve backup in the brake unit itself.
Now the BRK2012 is no longer available, the new version is BRK2022. Our part number is # BLU37TR. The new version does not have an internal battery. So if you lose power it will not function. It does have a built in superconductor that will activate brakes if brakeaway occurs, and will keep the brakes activated for... view full answer...
The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, # LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, # LC26VR, will of course be the right side as facing the slide-out from the outside.
The "Fixed" assembly will have the installation alignment flange of the shipping angle on
the right-hand side of the assembly, when looking at the "S" track on the gear rack. The "Fixed" assembly has
an... view full answer...
Your trailer uses an open eye leaf spring like # e24SR. Over time as the leaf spring softens the gap you are seeing will get bigger. As long as the leaf spring is not falling off the hanger when you raise the trailer weight off the axle they do not need replaced unless visibly damaged.
Since the overall length of the spring changes as the spring wears I recommend measuring the length of your spring on the radius of the spring(see image). Since this measurement remains the same it ensures... view full answer...
The Trailer Valet XL, part # TVXL2 with 2 inch ball and the # TVXL25 with the 2-5/16 inch ball are meant for use on level surfaces only, they wouldn't work well on the slope you describe..
Actually, I have a much less expensive and easier to use alternative. I'd install a front mounted receiver like # C31073; the front hitch will allow you to easily put that camper right where you want it, slope or no slope, every time. view full answer...
I spoke with the manufacturer, Command Electronics, about the 12V RV LED Puck Light # CE68ZR and found that it has a warm white - 3,500 kelvin rating. view full answer...
I have attached a page from the installation instructions for the Extang Solid Fold 2.0 Hard Tonneau Cover # EX83475-62.
The page shows the parts that should be used with the rear panel you said blew off. You can look at the page to make sure all of the parts shown are still with the rear panel. view full answer...
The general reason a battery needs to be disconnected for flat towing is because there are certain functions that need to be disabled to prevent your vehicle's battery from draining. You wouldn't want to get to your destination and unhook and then have a dead battery and not be able to move your vehicle. You should always follow your vehicle's manual to the letter to prevent damage to your vehicle.
If you want to install a switch to make disconnecting and reconnecting the battery simple... view full answer...
To initially adjust the brakes, you will need to raise the trailer and secure it on adequate capacity jack stands. Check that the wheel and drum rotate freely. Do not lift or support trailer on any part of the axle or the suspension system. Remove the adjusting hole cover from the adjusting slot on the bottom of the brake backing plate. With a screwdriver or standard adjusting tool like part # W80630, rotate the starwheel of the adjuster assembly to expand the brake shoes. Adjust the brake... view full answer...
I have a solution for you, it is a smaller fan unit but we have an item that will function in the way you are looking for. The MaxxFan Mini Plus Manual RV Roof Vent, # MA00-03851 that you linked to needs a fairly stable power supply of 12 VDC and draws slightly less than 2 amps to operate. Wiring directly to solar panel will not support this as the power will fluctuate greatly and eventually damage the electronics in the in the fan. To operate, you need a stable 12 VDC power supply from... view full answer...
While we cannot confirm for sure what the "L" means on the 11033L, the "L" does not make a differences when coming to fitment of the hub.
With that being said, the Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern and is designed for 3500-lb axles. Replacement hubs that have these specs typically use a # L68149 inner bearing and # L44649 outer bearing, as well as inner race # L68111, outer race # L44610 and grease seals with inner diameter of 1.719" and outer diameter of 2.565".
You'll... view full answer...
I have a solution for your clearance issue, but the Lippert Jack # LC285318 cannot be rotated. You can get a bit more clearance by using a longer ball mount like this extra long ball mount # D-26. It measures 12-5/8 inches from the hitch pin hole to the ball hole. This will give you more clearance. You could always rotate the whole jack, but you will have to drill some holes and may need to use different hardware depending on your trailer. Obviously you will have the switch and light facing... view full answer...
As you can see in the diagram I provided, the tilt is adjustable up to about 45°. The tilt mechanism has a pin that can be used in two different positions to allow a roughly 15 or 30° degree tilt or the pin can be completely removed for the maximum 45° tilt. If you click the provided link, you can see a product description video. view full answer...
That is a good question and it is certainly reasonable to think that might be the case but it actually is not. A ST225/75R15 trailer tire with a load range of D such as the Karrier ST225/75R15 Radial Trailer Tire - Load Range D # AM10256 will last just as long and perform just as well as its equivalent with a load range of E, the Karrier ST225/75R15 Radial Trailer Tire - Load Range E # AM10303.
Generally speaking, the higher the load range of tire, the more expensive, so as long as the... view full answer...
There are two different Thule Elite Van XT 2 Bike Racks, part # TH302043 for Sprinters or part # TH302013 for ProMasters. I have attached an install photo below of the model for ProMasters with bikes attached. I checked with Thule for you but this is the only photo they provide of the rack installed. view full answer...
Go To Results