4-1/16" x 2-1/8" Rectangle. LED trailer light functions as a clearance or side marker light. Unique double bullseye design. Durable polycarbonate housing and lens. Surface mount - hardware not included. 2-Wire design. PC-rated.
Features:
Specs:
Surface-mount lights install flat against the surface of the trailer, so a hole does not need to be cut into the trailer for the light. This type of light is installed using a flange or bracket that has mounting holes. And mounting hardware is used to secure the light to the trailer.
A PC-rated light produces a 90-degree angle of light to either side of its centerline for a total of 180 degrees of coverage. This beam pattern can be clearly seen when you are standing directly in front of the light, as well as when you are standing on either side of the light. When properly installed, this type of light can function as both a front clearance light and a side marker light or as a rear clearance light and a side marker light.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we are taking a look at the Optronics Double Bulls-eye LED trailer clearance or side marker light. This LED trailer light functions as both a clearance light and side marker light when properly mounted. It features a unique double bulls-eye design and it is an LED system. LED's make great replacements for incandescent lights. They last longer, they burn brighter, they're more efficient. With LED's you don't have to worry about replacing bulbs and you don't have to worry about brittle filaments.This unit contains a real nice durable polycarbonate snap on lens so it can be replaced if ever needed.
And it has a white housing. It is a surface mount installation. We have two mount holes right here. You gain access to those by removing the lens. You can simply take flat head screwdriver and just pop that lens directly off the housing.
Mounting hardware not included. It's a two wire design. White wire for ground, black wire for power. It's PC rated and SAE and Department of Transportation compliant.We're going to take a look at the measurements real quick and then we'll hook it up to power. Edge to edge going in this direction is about 4 and 1/16 inches.
Top to bottom is about 2 and 1/8 inches. And the overall depth is about 1 and 1/8 inches. The mount holes on the unit are separated on center by 3 inches.We're going to go and hook it up to power that we see it with power running to it and we will also turn off our overhead lights so you can see it in a low light setting. It sends out a really nice bright, consistent signal. Here you can really get a good look at the double bulls-eye design of the unit.
It contains a total of 10 LED's or 10 diodes so the multi-diode design really helps optimize the overall light output. The power draw at 12.8 volts is 0.087 amps and Optronics puts a lifetime warranty on the LED's.That going to do it for today's look at the Optronics Double Bulls-eye LED trailer clearance or side marker light.
Easy to install
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.