Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Check Your Local Ordinance.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today on our enclosed trailer we're going to be installing a Rackem 2 1/2 gallon gas can rack for enclosed trailers, part number RA-1S. This rack is also available in a 5 gallon rack which is part number RA-1L. Now because our particular trailer has wires at the top of the lip, we're not going to be able to install the rack up where it normally would go. Instead we're going to use a section of 2 by 6, and we're going to cut an angle on the back side of it to match the top angle of the rack. Now that we have all our 2 by 6 pieces in place, we're ready to install the rack. We'll use a level to make sure it's even, and then we'll go ahead and put some screws in to hold it in place. With that, that's all there is to it to installing the Rackem 2 1/2 gallon gas can rack for your enclosed trailer, part number RA-1S.
.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.



Luke J.
8/31/2020
Product is holding up very well