Features to know about

Full Bed Access: Folding Aluminum Design

When you need the entire bed, this cover folds up toward the cab so you can load large tools, plywood, or recreational gear without removing anything. The panels lock in place at a 90-degree angle using cab-mounted latches, so they stay secure for highway driving and won’t swing or bounce around. It’s perfect when you want to tow a 5th wheel or haul something tall but still keep a hard cover ready to close when you’re done.

Tough Protection: Black Urethane-Coated Aluminum Panels

Each panel is made from extruded aluminum coated in black urethane for a scratch-resistant, impact-tough surface. The aluminum construction shrugs off hail, debris, and daily wear while staying light enough to lift easily. It’s rated to hold up to 400 lbs, so you can count on the panels to stand up to rough weather and heavy use without bending or sagging.

Clean, Low-Profile Look: Less Than ½" Above Bed Rails

The cover sits less than half an inch above the bed rails, giving the truck a smooth, finished look instead of a bulky add-on. The low-profile design also helps with aerodynamics and keeps the lines of the truck clean. Even with the cover installed, you still have access to your stake pockets for racks or tie-downs.

Weather-Tight Fit: Seals Without Drain Tubes

Integrated weather seals block rain, dust, and snow from getting into the bed. There’s no need for drain tubes—just a tight, reliable seal that keeps cargo protected through bad weather and car washes. The cover latches shut whether the tailgate is open or closed, and when the tailgate is locked, your gear stays secure.

Simple Install: Clamp-On Mounting, No Drilling

Installing the cover doesn’t require any drilling or special tools. The clamp-on design lets you mount it quickly and square it up without hassle. Once it’s tightened down, you’ve got a strong, watertight cover that folds open in seconds using the built-in nylon pull cord.