Best 2022 Honda Ridgeline Truck Bed Bike Racks

I've only tried it once so far, but high marks. It takes about 2 minutes to put it on the tailgate. The bikes fasten with Velcro straps to the top. I have very heavy bikes, and one leaned a little on a short ride. No problem after cinching it again. For a long drive, I'd augment with tie downs, cables, and locks. If I had a receiver, I'd get a conventional carrier, but this is a cheap, viable alternative.

Arrived 2 days earlier than promised. Extremely easy to install. Just loosened up the straps and slid it off of the tailgate of my Ridgeline. All I have to do is slide it back on and tighten the straps. Will take less than two minutes. Padding is very thick and our bikes, including my wife's electric bike, will be well protected. If I could give the six stars, I would.

I used 2 inch square tubing cut the length of the tie down support bracket in my 2007 Honda Ridgeline and secured with a stainless bolt and wing nut, use a large enough washer to cover the diameter of the supply hole in the Honda Ridgeline bracket on the truck. A couple of notes: Be sure to use something as a cushioning gasket to insure a snug fit and to protect your truck lining. I used rubber or foam exercise mat cut to the same as the aluminum square tubing. Use a washer that a combination of hard plastic and metal to avoid the corrosive effects of dissimilar metals in contact with each other. last: My 26" full suspension bike fits, but I have swing it to one side slightly before i close the tailgate and lift the bike up and slide it down....It's a very snug fit but the suspension adds pressure to the tailgate and its works out very well. Or you could just use a tailgate extender.

I installed this bike carrier in my 2017 Honda Ridgeline. Shipping was super fast and got it the day after I ordered. The fitment is great and the installation took about 10 minutes. It is exactly what I needed!

Tracking order was detailed and exacting. I've not seen that with any other company. I put the tailgate pad on my new 2021 Honda Ridgeline, then tried an electric bike on it. It works perfectly and protects both the bike and the truck tailgate. So far I'm very impressed with the product.

I had spent weeks looking for the right purchase to carry bikes for my family and I. This solution is hilariously simple and perfect. I carry two full size and two kid bikes in my Honda Ridgeline. Such a convenience not messing around with a hitch rack.

Very satisfied with this product! It is plug & play out of the box, it takes 1-2 minutes to install, and it fit my Honda tailgate like a glove. The cover is lightweight yet fully protects my trucks finish. The Swagman is an excellent value.

This bike is of excellent quality. Every time I ride it I am amazed by its ride. It is excellent.

The Hollywood Racks Truck Bed Bike Carrier - Fork Mount - Bolt On, is just what I was looking for to be able to build a bike rack for carrying one of my bikes on my motorcycle. It was easy to mount and it holds my bike in place while riding on bumpy dirt roads, city streets, highways and even when I hit some twisty country roads. It's really easy to load and unload my bike when I get to where I want to ride. I use a velcro strap around the quick-release and the fork arm as an added safety as well as a couple tie-downs from my bike handlebars to my motorcycle passenger pegs to help distribute the weight on my rack. If you want to build your own DIY bike rack I totally recommend the Hollywood Racks Truck Bed Bike Carrier - Fork Mount - Bolt On.

Love this product! I built a great bike carrying system for my F-150 using two of these fork clamps. They are easy to install and extremely well made. No more tangled bikes and lots more room in the bed for other stuff! Best way to go for a nice bike rack system. Thanks, Phil T.

The quality of the rack is fantastic. Sadly the keys do not work on the Locking Quick Release Skewers. I've contacted Swagman about this and am waiting for a response.

Excellent Customer service and help for this product. Thank you Carol and Neil your the best.

This is not the first bolt-on 12mm thru-axle fork mount I've attempted to use, but it IS the only one I've ever actually been able to use properly. I'm always please with RockyMounts quality and this is no different!

Nice fit and finish.

Cheap alternative compared to having to buy a 9mm thru axle mount for the utili-track in my Nissan Frontier AND THEN having to buy an adapter for that! For under $10 I bought some parts from a local hardware store and made this mount fit the track. It's sturdy, and high quality.

Have used the block head bike mounts by Yakima on trips of 800 to 1500 miles with no incident. Easy to mount the bikes and they have not released even on bumpy roads. Great product for my truck box and bikes are always in view. Easiest way I have found to transport our bikes

With a little adaption the Yakima brackets mounted to my built in bed rails on my 2010 Nissan Frontier. With my truck cap this makes my bikes safe and secure, out of sight out of mind.

Linda and I recently ordered two Aventon Pace 500 NextGen E-bikes from [bike store] in Madison, WI. Not wanting to just toss our expensive new bikes in the back of the p/u when they arrive next month we promptly ordered the Thule Instagator from etrailer. My prior experience with etrailer came as a recommendation from a friend. I was able to do quite a bit of the research on etrailers website, the demonstration video extremely helpful and we placed an order. The racks were in-stock, shipped promptly, etrailer providing a very nice tracking link that included pics of the staff involved in processing the order and a map of the route all the way to delivery. Absolutely 1st rate service. The racks showed up in perfect condition about two days after placing the order, exactly as promised. We are very pleased with etrailer, will most certainly be ordering from them again and recommend this company w/o reservation. Nice job etrailer!

Installed in my Ford Ranger. With the dealer installed drop in bed liner on my truck, my bikes are too long to mount the front tire in the rack as I have less than 60 inches by a couple. So I mount with rear tire and the front tire at an angle in the front corner of the truck bed. Loading is a little awkward. I can’t secure the carriers (I have two) by closing the tail gate as my E-bikes are too heavy at about 50 lbs. each to lift over the closed tailgate. So I have to mount them with the tailgate open, then position the racks where I can close the tail gate with a good fit and then ratchet up the slack of the holding straps. With the bricks mounted this way the security chain built into the carrier is not long enough to go around the main part of the frame in fron of the seat. It has to go on/over the rear part of the frame. With the short trips I’ve taken so far the bikes seem reasonably secure. There is some sway from the front tires, but on long trips I will probably secure some how with a strap. Unloading is also not the easiest, mainly due to the weight of the bikes. Two people makes it much easier. Finally, the carriers could be easily stolen by simply pulling out the ratchet straps or cutting them. Recommend a security chain lock be attached to the carrier and also maybe the bike.

Well made, but you need to do something about the 3 straps...and how you can push a wet noodle up through the gap. Gonna have to put a sting down, and attach it to each stap to pull them up.

Product looks great. Fits our Fat Tire ebikes great. But your template is for the smaller mount. No big deal but you should caution customers before they drill into anything.

I bought this for my fat tire HIMIWAY ZEBRA E-BIKE to mount to the rails in my 2018 Toyota Tundra. The mount was sturdy. After looking all over the internet this was the best I could find. The issue I had with it is that the bike weighs 88lbs and it was difficult to get the front fork on the mount. But the bigger issue was the weight of the bike on the mount added allot of stress to the Tundra rail system to the point where it was flexing the front of the truck bed. I did not want to risk the potential damage to the truck through bumps and long hauls . I would definitely recommend this if you have a regular fat tire bike as it’s not as heavy and won’t stress the bed.

Thanks for the follow up emails. Received my interior saris fork mount carrier and already have people raving about it. Here is a photo for subaru outback 2014 with saris Thanks again

We bought the fork mounts and bike carrier base to use inside my Honda Element. We had been "stuffing" our bikes in the back and securing them with cords going all over the place...and the bikes still shifted while driving. This system holds the bikes VERY secure, even while turning corners. The installation was easy and the bikes fastened up quickly once the front tires were off. This was an excellent investment and I would recommend this system for anyone transporting bikes inside a car.

I’m a senior and was searching for ways to transport our ebikes without having to lift them. Fortunately I found the Inno Velo Gripper Bike Rack for Truck Beds and installed them on my utility tilt trailer. They work great, were easy to install and no lifting onto a car mounted bike rack needed.

Using the Grippers for carrying 2 ebikes, weighing 55 & 75 lbs. I know this is above the rated bike weights but so far they have performed well. My short bed keeps the 75# bike pretty well locked in front to back so that may help.

Holds my bike securely in the back of my truck. Quick and easy to loosen or tighten. Recommend to anyone making their own bike rack.

These are very nice fork cleats, powdercoated steel and neatly welded. I did need to drill them to 3/8" mounting holes as my bed rail takes 3/8" hardware and these come with 5/16". Once that minor step was complete I was able to bolt them to my bed rail easily. I would recommend these over aluminum fork cleats to anyone putting together a custom bike rack.

Perfect for hauling around my bikes. Super easy to setup on my 2020 Chevy Colorado.

The concept is good and the materials seem fine. The wheels ocme off with the design for attaching it to the tailgate (moves around) and managing the flap. I'm not even sure why there's a flap (useless). The straps/buckles for attaching the bikes are not the best choices.

Easy to set-up, adjust & use. Keeps the bikes secure and upright even on rough 4WD roads. I pull a camp trailer often, so couldn't use a hitch rack, but these are better anyhow because I can keep an eye on my bikes while on the road, plus, they don't stress the frame from a weird angle, the way some racks do. These were definitely worth the money. Very satisfied.

I love this bike rack…I use it for my Mokwheel Basalt…that’s 82 pounds of E-bike…holds like a champ…I adapted it to work with the track rack I installed on my truck…fantastic

It's been a great purchase -- the fork mount has worked out exactly as I hoped -- no fuss mounting of my Salsa Beargrease Fat Bike in the bed of my Ford Maverick pickup which has a flexed with slots made for a 2x6 to mount the bike. This is a high quality mount.

The Kuat bike fork mount works great! My bike attaches quickly and securely to the mount.

Not your fault but Rocky Mount. Doesn't really fit fork well as there is MUCH play and screwed in a far as one can go. Is not a 1 fit all for 12 or 15. Needs an additional gasket/grommet to securely hold. With all the extra play I can see the front fork breaking from stress in moving around.

This is an awesome product! I have been using it regularly for the last week and it is spot on. Easy to install and use as well!

The product review/installation video helped me make my selection. I selected the full size pad for 2001 Silverado 1500. Installs easily, fits nicely, flap in pad is positioned for easy access to tailgate latch.

This is my second - I'm replacing one that has worn out over 4 years of use. Used. Worn out. Worn hard. I like it enough I came back for another. Yes, the seams finally pull apart, and the fabric weathers - even the top strap broke. After four years. And I came back for another. This is a great product and mine has paid for itself over and over. Whether hauling one bike, two, three, or four. Highly recommended.