Most Popular Locks Not Included for 2020 Ford Transit T250

This is a great way to transport a bike. Just bolt the dirtbag to a surface and attach the fork. I have mine mounted in the back of our minivan and regularly transport my mountain bike inside the van. The dirtbag comes in sizes to fit most fork configurations. I have a through axle for my tandem bike, 100mm for my mountain bike, and now the 110mm for my 29+ mountain bike. They all have the same hole pattern so I just swap them out depending on which bike I am transporting.

That mount is the perfect solution for us. Our previous bikes had the older skewer axle mount, so I had to re-drill the base to match up with holes in bed rail. FantomWorks of Velocity TV fame fabricated and installed threaded plates under the bedrail so it made the swap quite easy! Thanks!!!!!

This is the 2nd time I have purchased this bike rack and it a good fit for the Sprinter van. The rack is sturdy and pretty easy to load while not taking up a lot of space. It does take a couple of days to install due to drying times on the adhesives for the rails that mount to the door.

The Thule Elite Van XT2 Bike Rack is just what I expected but the install instructions leave something to be desired. Nothing but pictures trying to describe the install. Even a few poorly worded sentences would have been helpful in some places. I have seen this noted in other reviews and [online]. Otherwise a quality product and I have been able to integrate it with my Kuat swing arm and bike rack that we were already using. I wanted to be able to add a 3rd bike to our setup without extending the length and still be able to open the rear doors without removing a bike. This all worked out with just a little modification. I did move the Thule bike rail install point 1.5" above the center install position to allow clearance over my wife's ebike. See photos.

This is a well designed rack. Adding and removing bikes is quick & easy. Just set the bike on & slide the padded hook down onto the bike frame to secure it; no straps required. If only one bike is transported, it does not interfere with opening the trunk on our Tesla Model 3. With 2 bicycles the trunk cannot be opened. For 2 bikes the Swagman model that can tilt might be worth the extra 22 bucks. This rack uses a bolt in the receiver hitch instead of a pin. This locks it securely preventing it from moving in the hitch & rattling. It also requires a wrench to remove it, good for theft prevention but one more thing to keep track of. For storage on the vehicle the top bar folds down. For storage in the garage, the left & right bars fold up & you can hang it using one of the hooks.

So far so good. The rack wiggles a bit, but that is expected. I have it on my 2007 Corolla and I have hit 65+ on the highway with it and have not had a problem. I would recommend getting a locking pin. The one included is threaded, which aside from security, makes it harder to take the rack on and off. I would also look into a DIY way to secure the wheels better. I am using some bungee straps which do the job no problem. The two bikes I carry are at the racks capacity.

I love this bike rack…I use it for my Mokwheel Basalt…that’s 82 pounds of E-bike…holds like a champ…I adapted it to work with the track rack I installed on my truck…fantastic

I have a 2021 Toyota Tacoma and they work perfect for my downhill mountain bikes, love them. Can load and unload without ever having to climb into the back of my truck

Neat design. That's the only positive. Shows up in a million pieces. Surface rust on some of it already. Need a hammer to use "quick release" pins to pivot. 1 1/4" adapter is not long enough for either car I tried, unless your hitch sticks out PAST your bumper don't even bother. Had to trim 2" section of rack to make it fit hitch. Had to grease pivot section because rough surface finish would NOT allow rack to pivot. If I didn't need it (and didn't spend 2 hours assembling) I would have sent it back. Worst bike rack I've bought since a K-mart contraption 30 years ago.

The bike rack is made for bikes with no fender, our bikes have fenders and a rack over the back tire. We added some padding for the back tire so the rack doesn't get scratched, it works just fine our bikes are secure.

One Year Later – Still Going Strong I’ve owned this rack for a year now, and I couldn’t be happier. It securely holds all 4 of my bikes, even on longer road trips, with no shifting or wobble. One of my favorite features is the ability to tilt the rack away from the vehicle—even when it's fully loaded. That’s a huge convenience and makes it super practical for daily use. Durable, easy to use, and thoughtfully designed. Highly recommend if you're looking for a reliable 4-bike solution.

This bike rack has worked well for us. We have a Jeep Wrangler, with the spare tire on the back of the tailgate, and needed a rack that would hold the bikes in a trailer hitch, and swing away so we could easily access the rear storage of the jeep. This has worked out perfectly! I did have to use a hitch extender to clear the rear tire, but that was expected. The rack works well, holds the bikes as expected, and is easy to use, and get on and off the vehicle. I am very satisfied!

Held up well over thousands of miles hauling bikes around full time rving. Almost impossible to get inner bike off without taking rack out of hitch. Wheel holders should be further from center bar as pedals have to be positioned a certain way to fit and still have rubbing issues.

Everything looked good except one piece was damaged. I just got off the phone with Korren to report the damaged piece and she is sending a replacement part. Both products, bike rack and receiver hitch otherwise looked to be very well built. Your company and representatives, Loren and Korren were very nice to work with on my purchase. Thank you

This rack has been great on my 2016 Nissan Rogue SUV, very sturdy and holds bike(s) securely. I've used it with a fat bike, a regular mountain bike, and a road bike. Amazingly this rack gave me a couple inches MORE clearance in my small garage than my previous hanging-style rack. The aluminum trays themselves are still in great condition, though other parts are showing some rust after 1+ years (and since I use it in the winter as well I leave it on most of the time). The tilt-down feature is great, but pulling the pin and reaching the knob to do this is awkward with bikes in place. When removing the bike, it can be hard to squeeze the lever on the hook that holds the front tire. (Maybe because of pressure when the hook is against the tire?)

I've had this hitch for a day and used it just once on my Miata (class 2). Going on a trip tomorrow and will use it on a Nissan Frontier pickup (class 3). It seems like a quality hitch for a very good price. I feel like buying one of those other brands (named after cities) you are paying a premium for the brand name. Hollywood provides a great value without gouging my wallet. I like the aluminum rails and the entire system is easy to use. Just holding off one star since I've only had it for a day. As a bonus it arrived a day earlier than it was scheduled!

I was sent additional mounting materials that don't correspond with my hitch or my bike rack. See the photo below. Are these materials for my Swagman STC2 Bike Rack Item #S64670?

Just put it together and that was easy. Still waiting to use it this summer. Expect it to be perfect as I've use an XCT 4 bike rack for 12 years. It's still fine but I don't need to carry that many bikes and wanted a lighter rack.