Summer Starts Here - Save up to 70%
# 1
Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
The wet bolts were just fine. But the "locking nuts" with the crimped edges were aweful. The 3 dimples each nut has were not useful. Many of the nuts I could use my fingers to spin them on the bolts. Never had locking pressure. I ended up going to local hardware store for much better locking nuts.
I bought a set of these bolts to replace the hardware in the triple axle suspension of my toyhauler. I had read about the benefits of a wet bolt kit, and after finding two broken shackle plates on my camper, decided I too needed to be able to properly lubricate the moving parts. These were a perfect fit and replacement for my original bolts. At the time I installed them I hadn't read about orienting the hole in the bolt to the 3 or 9 o'clock to ease pumping grease through them. I put them in at whatever orientation they were in my hand, but had no problem pushing 3 - 4 pumps of chassis grease through the zerk. I was able to observe grease flow out of the spring eyes around every bolt, and all of the zerk fittings stayed firmly in place when I wrestled the grease gun nozzle on and off. There were a few bad reviews about these press on fittings falling out, but I didn't see any evidence of that. I am very pleased with this purchase, and enjoy the peace of mind that comes with knowing I can properly service my suspension and hopefully extend the life of all the components in the system.
# 2
U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7-1/16" Long U-Bolts
Ordered a lot of parts for a dump trailer rebuild in Sept. Didn't install some of the final parts until Christmas break. THEY SENT COARSE THREAD NUTS INSTEAD OF FINE. I ruined 2 u-bolts and need all 16 fine thread nuts. I'm outside 60 days so I was told I'm on my own. I've spent $5k+ on etrailer. I'll find some place else.......
U-Bolts and hardware seem to be good quality. Package was delivered when promised. Very satisfied with purchase. Will be buying from E-Trailer again.
# 3
Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long
Just what needed for my trailer. My old leaf springs were so rusted that I was one pot hole away from being broken down on the side of the road. These new ones are perfect.
When I asked questions about my order they answered back quickly. Everything fit like it should. Yes time will tell if the springs are good.
# 4
Replacement U-Bolt with Nuts for 2" Wide, Square Trailer Axles - 9/16" Diameter
Ordering online is frustrating when your order gets denied for security purpose because payment method isn’t on file
Great product at fair price with fast delivery. Very pleased with the quality of that U-bolt
# 5
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
Well constructed
Bought this to replace the shackle links and hardware for an existing aluminum trailer, did not use the brackets. Bolt shafts are "flared" on the inside head end so you need a press to push them into the bracket. Otherwise, you need to crank down the nuts as you install them to seat the bolts properly.
# 6
Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
Excellent service and quick delivery and great price, all looks good, thanks for helping me out with these items that I can't find around my area anymore,AES
Bushings quiet the trailer for a short period of time. Bushings wear out and squeaks return quicker than I expected.
# 7
1-1/2" Square Trailer U-Bolts (Qty 2)
I'm working on a 12 ft long 1957 Corvette trailer. Easy install, and perfect fit. I dropped the axle to gain 3".
I purchased these U bolts to upgrade the suspension on my trailer. I would get a a lot of trailer sway when I was towing my jet ski trailer. I bought the trailer used and never really looked at the springs. Unfortunately for me, There was nothing but one U bolt strapped diagonally across the spring. I'm no suspension expert but I knew this could NOT be safe. I did extensive research on trailer suspension. It was difficult to find parts for a 11/2 inch square axle. It was until I came across etrailer webpage. They had everything I required to upgrade and make my trailer safe to operate on the road. It was actually criminal what the person did to attach the original spring. I am greatful nothing ever happened while towing. Now with the new parts installed, I feel a lot better and my trailer does not sway anymore. I will definitely purchase my trailer needs from etrailer from now on. The pictures and videos make finding what I needed so much easier. The complete transaction from order to delivery was extremely efficient and the customer service is absolutely outstanding.
# 8
Equalizer for 2" Wide Slipper Springs - 12" Long - 7/8" Center Hole - Zinc Plated
The products I received were exceptional. First class and top of the line. But I had to ship them back. Was my own fault. I ordered the wrong size. . Even the process to order them and receiving them was a pleasure. Never had such and easy experience before when ordering products on line or on phone. Even shipping it back had me blown away at how easy. The sales rep, Lori, is ver profession and knowledgeable and very polite and courteous. Was a joy to deal with. Wish all companies were modeled like y’all’s.
Easy to install about 10 min start to finish. About 45 min to replace 4 thanks E trailer.
# 9
Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 5-3/4" Long - 9/16" Center Hole
We have had great experience with eTrailer, These parts came in as described.
Etrailer was on point. Had the part and it was picked and shipped on a Sunday asap. The tracking information from the usps wasn't updated till the day of delivery which had me sweating, but Etrailer was awesome!
# 10
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 7/8" Rear
My 6' x 10' landscape trailer was a homemade by a prior owner. While it was mostly constructed very well, the spring hangers were not correct. The spacing for the springs was also wrong, and it had very little fender clearance. There was also evidence that the spring U-bolts had contacted the frame on occasion. (I do not carry loads anywhere near the 3500# axle rating.) I added an extra set of holes on the front hangers in case the ride height proved to be too much, but I like the way it sits with the stock holes. I don't think I'll be utilizing the extra holes. This kit was just the ticket to increase the suspension travel and fender clearance on my landscape trailer. Now it "sits right"!
I am sorry but I can not remember names but I talked with two very helpful ladies and could not have been happier with their assistance. Thanks again, the trailer build is going great.
# 11
Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs - 2-1/4" Links
Got the kit today. Some of the nuts were oval and would not fit on the bolt of course. Now I have to go to box store and find nuts that fit! Not very good quality control!!
The parts shipped to me a day earlier than I expected. I was able to install one side that same evening. Finished the other side the next day. Plan on going camping next weekend. The parts seemed to be of good quality. The installation was straightforward.
# 12
Tandem-Axle Trailer Hangers for 1-3/4" Wide Double-Eye Springs - 3-1/4" Tall Front
Worked for what I needed. No issues so far.
These are the lippert brackets, I bought for spares just in case I was to break one in travels. Alsome product.
# 13
U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles - 5-1/2" Long U-Bolts
It is exactly as described. It seems solid. I also ordered the springs, and they appear to be solid as well. I look forward to continuing to do business with etrailer due to quality parts AND great customer service from the likes of Shawnee and the crew. Thank you!!!
These did not fit my 3500 lb axle. It has been very difficult determining the correct size U-Bolts for my axle. It appears etrailer does not carry the size I need.
# 14
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front, 7/8" Rear
This is a great kit! It included everything we needed to replace the old, worn-out brackets on our 6'x10' trailer. The directions were helpful and the brackets and hardware are nice and solid. We've had zero issues with the leaf springs (purchased on etrailer.com, also) or the brackets. Would definitely recommend!
Excellent, had everything I needed and more for my trailer. Everything fit well!
# 15
Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 2" Long
Fast shipping for regular mail and right product. I say a review from another purchaser that said to get these with the 2” X 10” and an 1/8 swan equalizers, good thing I ordered these also. After 25 yrs and about 2000 cords of firewood I rebuilt my Western Dump, everything fit perfectly. Thank You! Pictures-Worn out parts and new installed
Excellent spring quality for my custom motorcycle trailer. Arrived quickly. Glad I ordered a nylon bushing though. It didn't come with one for the open ended side and it should have.
# 16
Wet Equalizer Bolt with Castle Nut and Grease Zerk - 4-11/16" Long - 7/8" Diameter
We have had great experience with eTrailer, These parts came in as described.
very needed bolt
# 17
DISCONTINUED - 1-3/4" Square Trailer U-Bolts (Qty 2)
The product was exactly what i was lookin for! Im using them on a '48 ford truck front axle. The pricing was better than a local spring shop. The customer service on the phone was above and beyond, which is hard to find these days! Thanks to the "e trailer" crew.
Small purchase but fast and courteous service. Very pleasant transaction. Thanks.
# 18
Front/Rear Hanger for Double-Eye Springs - 1-5/16" Tall - 9/16" Bolt Hole
Not bent enough. Open end measures over 2”. Not a huge deal but would be nice to have them closer to what they need to be before welding. I will have to tighten them up before full weld.
Just as good as the ones from the big box stores but way cheaper.
# 19
Spring Seat for Typical 3,500-lb, Round Trailer Axles with 2-3/8" Diameter
It looks like it will fit my 1954 Jeep CJ3-B Dana 44 axle tube, although it is 1/8" wider than ideal. Thanks
Worked great for my camper axle
# 20
Front Hanger for 2" Wide Slipper Springs - 5" Tall - 9/16" Bolt Hole
Worked as it should. New hangers, and a new axle and back on the road.
Website was easy to navigate and price was great. Parts are exactly what I needed to repair an older trailer that gets pulled several times a week
What our customers are saying:
"WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!"