# 1
Just what I need to easily wire up my snowmobile trailer, was tired of corroded wires, great product!
Good quality junction box. Made wiring my trailer for axle brakes and extra lights a breeze
# 2
Dielectric Grease for Electrical Connectors, 2 oz.
Great for terminal connections.
Connector bundle easy to install & worked great. Although the instructions say to feed the bed connector from the bottom it seemed easier to feed the bumper connectors from the upper the bed connector hole
# 3
4' Pigtail Wiring Harness for Pollak Replacement 7-Pole RV Socket
Just what i needed to fix someones mistake! This allowed me to replace the factory end on my GMC truck i just bought. The only issue was the yellow wire on the pigtail is for the backup lights and not the left turn signal. I just checked everything with a test light as i went and all was good.
etrailer Customer Service exceeds expectations... they have assisted in advising product uniformity and conformity.. The acquisition of the PK11998 will enable the unit to be returned to a state comparable to its original manufacturers designation. Looking forward to an expeditious installation
# 4
Mounting Bracket and Installation Hardware - Pollak 7-Pole, RV-Style Trailer Connector - Vehicle End
Easy installation
Good product only ting you need to buy 2 more screws because only came with 4 blacks
# 5
Pollak 10-Terminal Junction Box
Good product for what it does. Wish it was a little thicker. Makes a clean wiring job possible. Mounted mine inside a tool box along with the brake emergency battery. Did away with the "boat trailer" wiring the manufacturer had installed.
Had to replace the cable connecting my Springdale travel trailer to the tow vehicle. I ordered the etrailer 50-67-005 cable and the PK52248 junction box. The original cable was terminated in a standard electrical box with all of the connections done with wire nuts. When I opened the electrical box and pulled the wires out to have a look-see, one of the white ground wires came out of the wire nut. This is not the first time I have had a "loose wire nut" problem with this travel trailed so I decided the new cable would be differently. The j box was mounted to a 2 X 6 steel tube so I used 1/4 inch self drilling screws to mount it. I also used 1/4 in. self drilling screws to mount the metal cable clamps to hold the cables, going into the box. I used a couple of pieces of 3m mounting tape on the back of the j box to hold it in place to the frame while installing the mounting screws. I also made a small label to go in the lid of the j box to show wire colors and function. There was going to be five ground wires connected so I made a small bridge out of 1/2 in X .062 brass to go on the two end posts. I think this made a cleaner installation. When everything was wired and checked out I sealed the open grommets with RTV. The intermittent problems with the cable are now fixed.
What our customers are saying:
"I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future."