Built for high-output 24V trolling motors, this system adds circuit protection to quick-connect wiring with integrated charging leads. The 60-amp breaker helps protect the motor and batteries when you're on the water from dawn to dusk.
This system uses quick connects and integrated charging leads to keep your wiring organized when batteries need to come out, while adding circuit protection for higher-output trolling motors. A 60-amp breaker is included to help protect the motor and batteries when current demand increases, which is important for modern 24V setups and lithium batteries used during spot-lock, windy conditions, or heavy current. That protection matters when the system is actually being used on the water, not just when it's installed.
Battery compartments don't leave much room to work, especially once multiple batteries and a breaker are involved. With the connectors attached at the batteries first, you're not trying to crimp, stack, and tighten hardware deep inside a cramped space. The wiring and breaker layout go in with fewer awkward angles and less back-and-forth, so the install stays simple instead of turning into a job where you're fighting tools and clearance the whole time.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer. Today I'm gonna take a look at the Connect-Ease PRO 24 volt trolling motor kit with the 60 amp circuit breaker. Now, this kit right here is gonna power your 24 volt trolling motor using the plug and play kit. This is all pre-wired for a nice quick setup. As we mentioned, it includes the 60 amp circuit breaker, delivers a nice clean, reliable energy using corrosion-free marine-grade materials that'll work with either lithium or AGM batteries. And just to give you an example of how this would hook up, I popped up an insert there to show you how the cables will all hook up to the batteries.
Now, this kit is designed to provide pure clean power to any 24 volt trolling motor on the market. It is specifically designed to work with the Minn Kota, the Garmin, the Lowrance, and other branded trolling motors. We mentioned the 60 amp resettable circuit breaker also comes with the negative connection block. And if you notice on these connectors, they do have these heat shrinkable butt splices that are all included. Basically, your onboard charger can be integrated through those pre-wired connection, which are these heat shrinkable butt splices.
The plug-and-play option you can see, you just plug it in, clicks in place. To remove it, just pop it right out. This gives you a quick installation with everything all pre-configured. Does use corrosion-free tinned marine-grade materials, and this part is made in the USA. Now, the voltage on this is 24 volts.
Amperage is up to 150 amps. And the wired gauge size used on all these cables is six gauge wire. Now, if you do have any additional questions regarding this part or any other item we carry, please feel free to reach out to us so that we can help you get all your questions answered for you. But that should do it for a look at this Connect-Ease PRO 24 volt trolling motor kit with the 60 amp circuit breaker.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.