Connecting 3rd Brake Light on 2026 Ford Maverick With Snug Cap
Updated 03/15/2026 | Published 03/11/2026
Question:
Hi, I transfered my 2022 ford maverick snug cap to my new 2026 maverick hybrid and want to connect the third brake light, what will I need ? Any help woub be greatly appreciated.
asked by: Jean-Marc T
Expert Reply:
Hello Jean-Marc; to connect the third brake light you can use the 3rd Brake Light Logic Module # PP20-702. You will tap into the left and right brake/turn signal wires and run that up to your third brake light. The module will filter out the turn signal so only the brake light will come on on the truck cap.
(click to enlarge)
Bill
3/15/2026
Worked as described. I used it on a teardrop trailer I was building. Easy to use. I liked it enough to use again on another trailer.
Brad
3/15/2026
The module works as expected.
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Shop: 3rd Brake Light Logic Module
- Video: Complete Breakdown of the 3rd Brake Light Logic Module
- Q&A: Solution For 2023 Ford Maverick For Third Brake Light Wiring for Camper Shell
- Q&A: Wiring and Connectors to Power 2025 Ford Maverick Truck Cap 3rd Brake Light
- Search Results: roof rack for truck cap
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Powering 3rd Brake Light and Dome Light on Topper for 2025 Silverado 1500
- Q&A: Can You Use The 3rd Brake Light Logic Module With A 4-Pole
- Q&A: Connecting 3rd Brake Light in Leer Cap to 2019 Ram 1500
- Article: Trailer Lighting Requirements
- Q&A: How To Wire Dome and Third Brake Light On Leer Camper Shell
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Holiday 2025 | Best Gifts for RVing
- Article: Holiday 2025 | Best Gifts for Towers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
Gc
3/15/2026
Hello Jean-Marc. I used this module on my new 2026 Ram 2500 Power Wagon and Overland AT Atlas Topper and it works great. Not sure how your truck is set up, but I located the module behind the driver side tail light, because that's the side the topper's 3rd brake light and other electrical accessories were made available. Locating it near one of the brake lights gives you easy access to one of the brake indicator wires, so you'll only have to run one wire over to the other light. You can ground the third wire to any good body/chassis part that you can confirm is grounded with multimeter. I drilled and cleaned a hole for ground on the steal panel behind the brake light housing and properly weatherproofed it. Just a note - before I installed the module and ran the wire, I tested it with long jumper wires to confirm operation. Good luck!