How to Install Aluminum Trailer Fenders
Updated 10/27/2025 | Published 03/17/2025
Products Featured in This Question
Question:
I have a 2017 RoadKing single axle boat trailer with 14 wheels. It has plastic fenders. To change to aluminum fenders what mounting/step hardware would I need for the job?
asked by: Larry S
0
Expert Reply:
Hey Larry! If you're installing an aluminum fender like our CE Smith item # CE17100ATB you can either weld it on or use the Mounting Brackets for Trailer Fender item # CE26098G-2.
I have attached a picture that will show you these brackets installed. If you have any additional questions feel free to throw them into the comment box below.
expert reply by:
Jerred H
0
Mounting Brackets
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Plastic, Single-Axle Trailer Fender w/ Top and Side Steps - White - 13" to 15"
- Trailer Fenders
- Top and Side Step
- 13 Inch Wheels
- 14 Inch Wheels
- 15 Inch Wheels
- 11 Inch Wide
- Plastic
- Bolt-On
- For Single-Axle Trailers
- White
- Redline
more information >
Continue Researching
- Shop: Mounting Brackets for Trailer Fender - 13"/14"/15" Wheels - Galvanized Steel - Qty 2
- Q&A: Replacement Fender for Single Axle Escort Boat Trailer
- Q&A: Schematic Diagram for Stromberg Carlson Lead Jack Repair Kit LG-146059
- Q&A: Recommended Fenders w/ Built-In Steps for a Boat Trailer w/ 12" Wheels
- Article: Trailer Lighting Requirements
- Q&A: Mounting Brackets For Fulton F008574 Wheel Fender
- Q&A: Plastic Fender Recommendation for Shorelander Trailer with 14 inch Wheels
- Q&A: How to Select the Right Fender for 2000 Escort Trailer
- Q&A: How are Fulton Plastic Top and Side Step Fenders Attached to Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern
Jerred H.
10/27/2025
Hey Larry, how did the swap to the aluminum fenders on your RoadKing trailer turn out? Did the mounting brackets give you the fit you needed? Your update could make it easier for others planning the same upgrade.