How to Uninstall/Reinstall the Replacement Tail Panel Assembly for an Extang Solid Fold 2.0
Published 08/23/2023
Question:
My rear panel of my solid fold cover became separated from the middle panel. I removed one of the hinge caps and slid the rear panel back into the round channel thinking I was reconnecting the panel. But now, the rear panel will not fully fold back. What am I doing wrong?
asked by: Richard V
Expert Reply:
I'm not quite sure what's happening but I can tell you for sure how to install the Replacement Tail Panel Assembly for Extang Solid Fold 2.0 Hard Tonneau Cover # EX83475-62 according to Extang.
You're on track to start by removing the end caps on one side and sliding the old panel out. To replace it you'll just need to rotate the panel about 45° and slide it back into the place of the old panel. Finish by replacing the T20 Torx screws and endcaps.
If you're still having trouble I'd suggest checking out the channel on the panel to make sure it's not damaged.
Product Page this Question was Asked From
Replacement Tail Panel Assembly for Extang Solid Fold 2.0 Hard Tonneau Cover
- Accessories and Parts
- Tonneau Cover
- Panels
- Extang Solid Fold 2.0
- Extang
more information >
Continue Researching
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Q&A: How Does Rear Panel of Extang Solid Fold 2.0 Install/Remove
- Shop: Replacement Tail Panel Assembly for Extang Solid Fold 2.0 Hard Tonneau Cover
- Q&A: Removing Damaged Cab Clamp From Extang Trifecta Tonneau Cover
- Q&A: tonneau seal
- Q&A: How to Install the Rear Panel on a Extang Solid Fold 2.0 Tonneau Cover
- Q&A: How To Find Serial Number For Replacement Tarp Of Extang Tonneau Cover On 2008 Ram 1500 Short Bed
- Q&A: What Holds The Tail Hinge To Panel Assemblies On Extang Solid Fold 2.0 Hard Tonneau # EX83450