Recommended RV Camera System For A 2022 Grand Design Momentum 395MS

Updated 02/22/2023 | Published 02/21/2023

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen

(709)

$594.50

Furrion Vision S Wireless RV Backup Camera w/ Night Vision - Rear Mount - Black - Qty 1

(62)

$194.88

Replacement Shark Fin Camera Mounting Bracket for Furrion Vision S RV Camera Systems - Black - Qty 1

(294)

$33.24

Pollak Light-Duty Toggle Switch - On-Off - 12 Volt - 10 Amp - 6" Wire Leads

(8)

$8.74

Question:

I have a 2022 Momentum 395ms Grand Design and its prepped for a rear camera and I am guessing it has the bracket on camper already because it has something up on top looks like a bracket. I would like to install a camera there on rear and even put one inside my garage to watch my equipment thats tied down incase something would get loose. I want a 7inch screen for the Vehicle. So Im guessing I need the monitor and bracket for the vehicle, rear camera only for the rear and a camera and bracket for the garage? I am looking for a material list so that i can purchase. Thanks for the Help

asked by: John P

Expert Reply:

If you're already prepped for a camera system it will most likely be for Furrion and you should see their shark fin camera mount # FRCBRKT-BL. If not, I'll need to know the brand to find the correct system to plug in.

Assuming you are setup for Furrion the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision # FOS07TASF you were looking at would give you a rear camera and 7" monitor, like you were wanting. This will have the shark fin mount as well as you can't buy just the camera without it. You can just pop the camera out of it and install it in the mount already on your camper or swap them out as popping the camera out can be a bit of a challenge.

You could use the Furrion Vision S Wireless RV Backup Camera # FCN48TASF to get an additional camera for the garage, but it might be a bit of a challenge to get to the running light wiring to power it. If you can't get to it then you could just run it to your DC distribution panel and install an inline switch like part # PK34513 to cut the power when it's not needed so you aren't draining the battery.

I've attached two installation videos below to help walk you through the process.