Determining The Correct Replacement Drop Leg Return Spring For 10,000lb Side Wind Trailer Jack
Products Featured in This Question
Question:
Where can I find return springs for jack feet
asked by: M S
0
Expert Reply:
I would be happy to help.
The correct replacement return spring for the jack feet on your 10,000lb side wind jack will be dependent on which brand it is.
For example if you have an etrailer or Ram branded jack such as the # TJD-12000SP-F2 then you would want the Replacement Return Spring # TJD-12000-RSP.
However Bulldog jacks do not have a replacement return spring, so if it goes bad the jack needs to be replaced.
I included videos of the products mentioned for you to take a look at.
expert reply by:
Samuel C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Return Spring for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Video: Review of etrailer Replacement Return Spring etrailer Ram Square Direct Weld Jack - TJD-12000-RSP
- Shop: Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 12,500 lbs
- Shop: Pro Series Square Jack - Drop Leg w/ Non-Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Shop: Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K
- Shop: Square Jack w/ Crank - Side Pin Drop Leg - Spring Return - 10K Lift - 25-3/4" Travel
- Search Results: 3 wire
- Q&A: Replacement For 12,000 lb Drop Leg Jack
- Search Results: gen y pintle
- Video: Breaking Down the Bulldog Square Jack
- Shop: Mini Clearance/Side Marker Light w/ Grommet - Submersible - Amber LED - Amber Lens - 9" Pigtail
- Shop: Pro Series Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Q&A: Dimensions of the Replacement Return Spring Part # TJD-12000-RSP
- Search Results: 3/4 marker lights
- Q&A: Replacement Spring for Bulldog Sidewind Jack with 12000-lbs Capacity
- Q&A: Can the Drop Leg Plunger Pin Be Relocated on the Square 10K Direct Weld Jack
- Search Results: b&w puck
- Search Results: battery connector
- Search Results: anderson connector
- Search Results: weld~on trailer jack
- Q&A: Replacement Wheel Stud For Dexter Hub & Drum 8-219-13UC3
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Choosing Spring Return Or Non-Spring Return and Handle Recommendation For Bulldog Square Jack
- Video: Review of the Gen-Y Anti-Rattle Clamp for 3" Hitch Receivers