Replacement Spring for Bulldog Sidewind Jack with 12000-lbs Capacity
Updated 08/04/2020 | Published 07/31/2020
Question:
500212 kit, is it possible to buy just the spring?
asked by: Kurt S
0
Expert Reply:
I have a solution for you, but in order to replace the spring component on your Bulldog jack you would need to purchase the entire Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity # BD500212. This would be the only way to get the appropriate spring for this jack.
Parts like this do malfunction occasionally, so it might be worth having the extra parts on hand in the event that the gears stripped out at some point in the future. You could also completely change all of the components out and give yourself a mostly new jack.
expert reply by:
Erik B
0
Continue Researching
- Search Results: pro series jack parts
- Shop: Replacement Return Spring for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Search Results: 3 wire
- Video: Review of etrailer Replacement Return Spring etrailer Ram Square Direct Weld Jack - TJD-12000-RSP
- Search Results: gen y pintle
- Video: Breaking Down the Bulldog Square Jack
- Shop: Gooseneck Hitch
- Shop: Replacement Jaw Spring for Signature Series Fifth Wheels
- Search Results: jack thrust bearing
- Search Results: thrust bearing
- Shop: Tonneau Cover
- Shop: Curt Spyder Gooseneck Trailer Hitch for Fifth Wheel Rails - 30,000 lbs
- Shop: Demco Trailer Coupler - Flat Plate Mount - eZ-Latch - Black - 2-5/16" Ball - 21,000 lbs
- Video: Bulldog Square Jack Review
- Q&A: Can the Drop Leg Plunger Pin Be Relocated on the Square 10K Direct Weld Jack
- Q&A: Determining The Correct Replacement Drop Leg Return Spring For 10,000lb Side Wind Trailer Jack
- Shop: TruXedo TruXport Soft, Roll-Up Tonneau Cover
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Shop: Spacer Kit for Timbren Suspension Enhancement System
- Search Results: 1201 oil cap
- Q&A: Replacement Return Spring for Bulldog Square Jacks
- Shop: Replacement Bearing for etrailer and Ram Square Jacks - 10,000 lbs
- Q&A: Recommended Replacement Gears for a 015796 Hammerblow 180 Series Jack
- Video: Review of the Gen-Y Anti-Rattle Clamp for 3" Hitch Receivers
- Q&A: What is the AUX Power Pin for on a 7-Way Trailer Connector
- Video: Let’s Check Out the Nosing Edge Trim for Enclosed Trailer
- Video: Checking Out the Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Shop: Trailer Wiring
- Video: Let’s Check Out the Replacement Bearing for etrailer and Ram Square Jacks