Troubleshooting RVS Camera System Where Side Camera Sticks On After Blinker
Updated 04/02/2024 | Published 08/12/2021 >
Question:
Hello - I have a 2018 Coachmen Orion that has an RVS-770619N factory installed with a backup camera and two side cameras. After taking the RV out of storage after almost a year, I noticed something peculiar happening with the camera. I usually leave the rear view camera on while driving, and then when I use the turn signals, it switches to that view for about 5 seconds or so and then goes back to the rear view. But yesterday it stuckinch on the side view and the monitor buttons would not respond at all to change the view, power it off, nothing. After I got home, I let the RV sit for a while and when I came back out and tried it, everything worked as usual. I left the RV running for about 15-20 minutes, went inside and tried it again and everything was stuck. Any idea on what my issue may be? I am leaving for a trip this weekend, and I am pretty concerned driving without it working properly Thanks!
asked by: Jim S
Expert Reply:
When the view is stuck what is the lighting functions of the setup doing? Are any of the turn signals or brake lights sticking on at the same time or are they functioning fine?
If the light functions are staying on you have a lighting short that is confusing the camera system. If the lights are functioning fine the issue would be the multiplexer which you could replace with the # RVS-501N.

Product Page this Question was Asked From
Rear View Safety Multiplexer Box - 3 Channel
- Accessories and Parts
- Backup Camera
- Multiplexer Box
- Rear View Safety
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Rear View Safety Multiplexer Box - 3 Channel
- Video: A Closer Look at the Rear View Safety Multiplexer Box
- Q&A: Troubleshooting An Everchill RV Refrigerator That Wont Get Cold
- Search Results: ice maker
- Shop: Rubber Wiper Seal and Bulb for RV Slide Out - Stick On - 60' Long x 3-3/16" Wide
- Shop: Rear View Safety Backup Camera System for Dodge ProMaster 2010 and Newer - 7" Mirror Monitor
- Shop: Rear View Safety Switcher Box
- Q&A: Troubleshooting An RVS RV Camera That Stopped Working
- Q&A: Can I Run a 14,500 BTU Furrion Chill Replacement RV Air Conditioner on a Dedicated 20 Amp Circuit?
- Shop: Furrion Chill HE Replacement RV Air Conditioner Unit for Furrion Setup - 13,500 Btu - White
- Shop: Rear View Safety Universal Mirror Monitor - 7" Color Screen
- Search Results: power connector
- Shop: Rear View Safety Adapter Cord w/ Power Cable - 5 Pin Male to RCA Male
- Q&A: Rear View Safety Switcher Box RVS-501N-3 Wont Trigger
- Video: Hands-On with the Rear View Safety Adapter Cord w/ Power Cable
- Q&A: What Type of Cable Connector is the Rear View Safety Adapter Cord
- Article: Stability Control for Heavy Duty Vehicles
- Shop: RV Covers
- Shop: RV Mattress
- Video: Replacement Step, Motor, and Control for Kwikee RV Electric Steps: The Breakdown
- Q&A: Replacement Multiplexer for Rear View Safety Camera System
- Q&A: Replacement Multiplexer For Rear View Systems Universal Backup Camera Model RVS-770619N
- Search Results: rv and camper steps
- Search Results: rvs camera
- Video: Rear View Safety Universal Mirror Monitor Feature Review
- Video: All About the SuperSprings Custom Suspension Stabilizer and Sway Control Kit
- Video: Complete Breakdown of the SumoSprings Solo Custom Helper Springs-SSR-121-40
- Shop: RV Camera
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Search Results: suspension enhancement
Ray S.
3/31/2024
Would this fix apply to an earlier model 2007 Winnebago Sightseer? My blinkers work on the outside but on the inside the right blinker light is stuck on and the monitor is stuck on the right camera. The alarm sounds every minute or so since it thinks the right blinker stuck is on. This problem is intermittent which I would think would rule out components on the fuse box? Should I replace the multiplexer and the wiring harness? I have not taken it apart yet. Thank you!