What Size Bolt to Use with Rubber Bumper for Enclosed Trailer Ramp Door # 37210715

Question

Question:

What screw is used to hold this bumper into place?

asked by: Wil P

0

Expert Reply:

The hole diameter of the Rubber Bumper for Enclosed Trailer Ramp Door # 37210715 is 3/8 inch so you'd want to pick a screw or bolt with that diameter to fit the best. We have a 3/8 inch diameter lag bolt with part # FA74521 which might work for your application.

expert reply by: Jameson C

0

Answer 1

To hook up a trailer jack to a 12 volt battery you need to make the connection from the jack's power wire to the positve post on the battery using a ring terminal, like part #DW05705-1. If you don't already have a battery on the trailer you…

view full answer...

Answer 2

The PS-8 screws should work very well going into either material you mentioned. The threads are coarse enough that they'll get good hold on the aluminum or the rubber. For best results, you'll want to ensure that as many screws as possible go…

view full answer...

Answer 3

Hey Phillip. The Superwinch Terra Series ATV Winch item #SW1125230 definitely has the ability to do what you're wanting it to. It has a 50' rope and 2,500 lbs line pull. You are correct the 120v winches like item #DL25514 are going to run you…

view full answer...

Answer 4

Hi Robert; aside from mounting hardware (if you are bolting it on and not welding) you will need to add a 12V deep cycle RV/Marine battery like #34276285 and some wire to run from the #e33VV to the battery. If you already have a battery the cables…

view full answer...

Answer 5

The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.

view full answer...

Answer 6

The brake pads on the 12" Dexter Electric Drum Brake Kit #23-180-181 are 3/16" thick. Dexter Axle recommends replacing them once they get down to 1/16" thick.

view full answer...

Answer 7

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...

Answer 8

The first thing you need to do is look for any axle tag or etched axle number on the crosstube itself. Sometimes this information is inside the axle hubs if the axles came as a complete assembly. The axle information can also be found on any…

view full answer...

Answer 9

Hello Dave. To install the Dexter Self-Contained Hydraulic Jack #DX72CR you will need mounting hardware since that is not included. You will also need a 12v battery like the Bright Way Deep Cycle RV Or Marine Battery #BRW44FR to power the jack.

view full answer...

What Size Bolt to Use with Rubber Bumper for Enclosed Trailer Ramp Door # 37210715

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching